How to code silver crest dt 33137 to tv roadstar
Set-up (Programming) procedure is too much to type in here, and is not practical and it will differ brand-to-brand remote controls. If you wish to get more; check the sites linked here. The site has set-up code list & set-up procedure to many popular brand remote controls. The site has general set-up codes to check with TVs and other devices are given, in the order of the 'device's brand name list' in alphabetical order. Set-up code list to many brand remote controls also is given. Pull up older posts. Search the sites by type in the brand name to your device in its search box at the top right part of the display window. It will help you to find the document easily.
https://homenol.blogspot.com/
https://remotesearch.blogspot.com/
https://electronicshelponline.blogspot.com/
https://electrohelponline.blogspot.com/
Programming Notes
• If your device does not respond to the remote after trying all codes listed or your brand is not listed in the code list, use the Auto Code Search method to program your remote.
•
Sometimes the first code that "works" with your device may operate only a few functions of your device. There may be another code in the code list that performs more functions. Try other codes from the code list for more functionality.
This is a trial and error procedure; and quiet time consuming. You might have to check different codes said for your device./
3/26/2018 9:12:00 AM •
Roadstar...
•
261 views • 0 helpful votes
I can't get a picture on my Roadstar LCD8082D TV
The TV has two main sections One is the Audio component. And 2 is Video section. Since they are Separate and not dependent on one another with the exception of synchronization; (matching Voice to the Video), one section may work just fine. The other non-working section in your case is the Video. Over time various internal parts age and wear out from use or hot/cold. In the Video section a series of Capacitors, resistors, diodes, and transistors on a circuit board make up the Video portion of the TV. One or more of these electronic parts are going bad or totally defective. The only solution is a replacement circuit board. Do not waste your money on repairing a circuit board. If you cannot obtain a replacement circuit board, then the Road-star is now a Road Accor.
Jammed CD
remove the unit,, and take the top off, inside you will see the sensor that travels along the disc, 3 screws will release this,, and you can remove the disc,,
8/2/2010 5:19:15 PM •
Roadstar...
•
110 views • 0 helpful votes
Radio stations
The +12V_Memory (pin 4 on A connector) must be connected to a permanent (not shutoff by ignition key) +12V.
HTH
1/22/2008 10:15:20 AM •
Roadstar...
•
158 views • 0 helpful votes
Not finding what you are looking for?