Roadmaster Car Audio & Video - Recent Questions, Troubleshooting & Support
After installing the unit the face will not light up or come on the two buttons over and under the volume button will light up
Double check the red..yellow and ground wires..sounds like your not getting power.. check fuse in unit itself.. when installing any component in a vehicle..triple check and use things like solder and shrink wrap..always remove negative cable from vehicle battery prior to starting work or adjustments .also prior to removing cable from battery..reference owners manual.. some vehicles need to be disconnected a certain way to avoid future electrical and drivability problems..also ensure faceplate is secure
How do we hook up
Hi there,
First of all I would recomend that you consult your user's manual that should have been in the box when you purchased your reciever. Your CDR and MD in/out jacks should not be used for an EQ. Your EQ process should take place after everything else in the signal chain is completed and right before your final amplification. If you have no designated in/out for an EQ then you may have to find some other way of processing the signal. Perhaps a pre-amp may be needed in order to bring all of your signals together to then run through your EQ. Sometimes some amps have pre-out/in RCA jacks. These can often be used for an EQ.
Post further comments for more help.
Good Luck!!
Thanks
I need instructions in english
Follow the link below and you should see a download link of the manual from the page.
http://caraudio.manualsonline.com/manuals/mfg/roadmaster_usa/vr500cs-bt.html
Hope this was helpful?
Not finding what you are looking for?