Riccar Logo

Riccar Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 61 Products
  • 777 Answers
  • 40K Views

Here's the manual for your machine. Download and keep it because you will probably be needing more in the future.


RICCAR 9900 Instruction Manual

Riccar Sewing... | Answered on Jun 19, 2018


To found this in a storage unit and don't know very much about it but it works just fine. There is no visible damage. Comes with plastic cover. AC Service Cheapest Aircon Cleaning Servicing Singapore Air Conditioning...

Riccar Sewing... | Answered on Jun 11, 2018


Sounds like it's shorting.
out. Be careful, unplug it before you check the pedal for loose wires etc.

Riccar Sewing... | Answered on Jun 03, 2018


Lay the vacuum on the floor upside down, remove two screws to remove bottom plate to get to the lightbulb

Riccar Vacuums | Answered on Jun 02, 2018


Hello, Refer to page 9 of this owners manual. It involves removing a plate on the bottom.
http://media.riccar.com/manuals/8000_Owners_Manual.pdf

Riccar Vacuums | Answered on Jun 02, 2018


Sounds like the motor is trying to run but the other machine parts are not moving. If your machine is an older mechanical (not computerized), then it's very possible the machine has seized due to lack of regular cleaning and oiling. Avoid trying to run the machine in this condition as it can damage the motor.

Wheel on right side that controls the needle up and down is very tight...

Riccar Sewing... | Answered on May 22, 2018


Where could I get a back looper for a Riccar rl-924dr

Riccar Sewing... | Answered on May 12, 2018


Increase the top tension. It should pull up the bobbin thread into the fabric.

Riccar Sewing... | Answered on May 02, 2018


Remove the screws holding the cover that holds the handle in to remove the handle. Reverse the procedure with the new handle.

Riccar Vacuums | Answered on Apr 28, 2018


An 8750 is likely at least 20 years old but still may have lots of life left. I still have 8600 series Riccar vacuums brought in to my vacuum shop for service. You may have a loose wire, bad switch or power cord. I would take it to my local Riccar dealer to diagnose and repair.

Riccar 8650/8625... | Answered on Apr 28, 2018


Your 8955 could be as old as 18 yrs. Try tightening the screw holding the handle in, it could be loose allowing the handle to move back and forth enough to keep the switch from activating.
If it's an older vacuum or is used heavily it could have cracks in the body where the handle screw attaches or some damage inside the vacuum body where the handle bottom goes into.
If that doesn't help, Remove the bag door, remove the screws at the top to remove the cover to gain access to the area where the switch and wiring is located to inspect for the cause. When you push the lever at the top of the handle a lever going down activates the switch. It doesn't take much play in the handle to make the switch go on and off.

Riccar Vacuums | Answered on Apr 22, 2018


Sorry to say, but usually misthreading is the culprit. The machine must be threaded "each thread" in the correct order (usually upper looper first, then lower looper) and following the correct threadpath. Also, the presser foot should ALWAYS be raised when threading. Give each thread an extra little tug (grasp thread below the thread tree and also below the tension disk) to make sure it seats completely.

Riccar Sewing... | Answered on Apr 13, 2018


RICCAR R950 Instruction Book

Riccar sewing machine manuals

Sewing machine Riccar Super Stretch 505

Even if it's not your model machine, the threading instructions and basic use would be similar.

Riccar Sewing... | Answered on Feb 17, 2018


The armature should be cleaned and dressed when the brushes are replaced as they get full of carbon and can spark.

Riccar 8850... | Answered on Feb 11, 2018

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Riccar Experts

ray gallant
ray gallant

Level 3 Expert

62046 Answers

Tom Chichester

Level 3 Expert

51371 Answers

Bill Boyd

Level 3 Expert

53745 Answers

Are you a Riccar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...