Remington Garden - Recent Questions, Troubleshooting & Support
Remington 4620 fuel line diagram
Check this out https://www.google.com/search?q=Remington+4620+fuel+line+diagram&rlz=1C1ASUM_enPH918PH918&source=lnms&tbm=isch&sa=X&ved=2ahUKEwi1mr7S-s72AhXSsVYBHUBpCcMQ_AUoAXoECAEQAw&biw=1517&bih=736&dpr=0.9
I need coupling collar for my remington pole saw
My connecting nut was broken to the extent the threads were shattered. I cut off the rest of the plastic nut with an oscillating tool. Used the same tool to extend the slits on the plastic male piece then used a 1 3/4" E-Z hose Clamp from the auto store to squeeze the slotted piece. Works great and with the E-Z handle on the clamp it's easy to adjust the pole length. Cost was less than $5. May have to use a pair of pliers to turn the E-Z tight enough. Will attempt to load a picture.
9/6/2021 9:09:57 PM •
Remington...
•
Answered
on Sep 06, 2021
I have a older remington gas powered chainsaw
An impulse line from the crankcase pressurizes the oil tank to force oil to the chain. On the bottom of this line in the oil tank is duck (one way) valve. I think it has failed (open) and you are sucking bar oil into the crankcase. Loosen the oil cap before putting her to bed to help stop the bar oil from weeping. Key word Help. LOL HTH
Lou
If this doesn't solve your problem try here:
ArboristSite.com Chainsaw thread (free to join)
http://www.arboristsite.com/forumdisplay.php?f=9
Do a search for your saw it has probably been asked and answered. They will help if my suggestion doesn't work and you can't find an answer.
Are brushes available for remington 106890-02
Remington Pole Saw Carbon Brushes
If you're Remington Pole Saw is slowing down, throwing sparks, or not starting you may need to replace the carbon brushes. Replacing brushes and cleaning commutator early can prevent damage to motor armature!
Remington carbon brushes on E-bay Search for:
Remington Pole Saw 8 AMP Carbon Brush
2/8/2020 7:24:50 PM •
Remington...
•
Answered
on Feb 08, 2020
Remington Pole Say
check for a roll pin in the gear or shaft that has sheared off
check that the square end of the drive shaft is not rounded off or that the square drive in the gear is in fact locking on the drive shaft and not turning from worn out
12/28/2019 8:09:51 PM •
Remington...
•
Answered
on Dec 28, 2019
Replacing trigger switch for remington pole saw
To change that trigger switch on a Remington saw, you need to open up the two handle halves and expose the switch. The wires are just "poked" into the switch, so you can make a tool to release them. I used a 1/16" diameter short length of wire and flattened about a 1/2" of it on an anvil. Push it in next to the wire and the wire will pull out, wiggle the tool a bit and it will pull out too. Push the wires into the new switch and put it all back together.
The switch is probably a #077525S ...seen them out there for $8 to $15.
9/13/2019 4:08:11 PM •
Remington...
•
Answered
on Sep 13, 2019
Not finding what you are looking for?