Relisys Computers & Internet - Recent Questions, Troubleshooting & Support

Here is a FREE download that may help you! Know this may be a DEMO version and may be crippled? How to Resize Video for Smaller Resolution and Size Anthony

You need to install drivers for your graphic card

LCD monitors use CFL lighting behind the liquid crystal display. There is an inverter circuit just for the CFL lights which requires some of the DC current from your adapter to be converted back to AC. most likely your inverter was blown. Your only solution, in that case, is to take it to a repair shop to have any blown electronics replaced... or just get a new monitor (which might be about the same price as a repair).

I Am not sure if this is the kind of TV that you are asking about? I tried my best to help. Setting the sleep timer Samsung TV Sleep timer shortcut Forums How Do Turn On The Sleep Timer of My TV

http://www.manualslib.com/r/relisys.html

Well my Acer AL1711 finally gave up in as much as the screen flashed briefly at switch-on then went blank, regardless of brilliance setting so I decided to take it apart and try to fix it. The good news is that IT WAS NOT THE LAMPS that I feared in my earlier post and was easier than I had ever dreamed! First allow a good period of time for the internal components to discharge before starting. Remove the plastic clip at the base hinge to expose 4 screws - remove all four to release the stand. Then remove the 4 black cross head screws that appear to hold the back on, they do but there is more to do. Carefully tease the silver surround away from the case, best to start in the centre of each side and finish at the corners. There are many plastic clips to release before the surround comes away. Now remove the four cross head screws holding the pushbutton switch circuit board. The whole assembly can now be removed from the case and reveal a metal cover held by 2 SHORT (remember that!) SHORT! threaded machine screws. These once removed will allow the case to be slid away from the holding tabs located down the edges of the cover and removed. Now unplug the connectors from the board that has the mains input connector attached to it. You will see a heatsink with 4 electrolytic caps above it. Silly ACER designers, have placed the capacitors so that they get all the heat from the heatsink! Yes folks, the capacitors are above the heatsink when the monitor is in its normal operating position! So all the convected heat dries them out, nice. So the fault is due to a silly design error! Replace all 4 capacitors, two of them are 1000uF at 16V and the other two are 470uF at 16V, all radial types. Try and get capacitors with the highest operating temperature, at least 105 degree types and remember these are polarised, make sure you connect the capacitor + wire to + on the circuit board. You should have no problems with re-assembly but don't put the wrong screw where the short ones went or you are liable to see it come out of the screen LOL! Most important - - Don't forget the screw holding the earth tag to chassis. Good Luck, you will be amazed how much brighter the screen is now!

Hi,I have same monitor and problem,still unable to resolve, I been told to try the monitor on other PC to see if the actual problem is in the monitor or originates from the PC.

When it have this kind of error is a problem of the powerboard. Anyway you must open it and look at the all capacitors and if are them inflated, if them are inflated must change them. But can be a problem with inverters... control the transistors - MOSFET on the powerboard. Good luck!

try separating wires. touching wires cause cross-talk of signals.

separate the wires in back. Touching wires causes cross-talk of signals.

Maybe that site uses software that your machine is not up-to-date on. Make sure all your software components are up-to-date (OS, Motherboard Drivers, Video Card drivers, Browser, Java, Flash, etc.)