Razor Sport & Outdoor - Others - Recent Questions, Troubleshooting & Support

I had this same issue with the Razor E100. I couldn't even remove the plastic cap it was so recessed. Here's what worked. The value comes from the factory very recessed in. It's so far in it's hard to remove the cap with your fingers. You'll need to get the value loosened up and pushed out a bit. You will do this from the other side of front wheel using the hole. The value can be manipulated slowly to stick out about an inch from the plastic wheel. It takes some time and patience. First, you’ll need to turn the scooter over and rest it on the handle bars and back of the deck. Put a towel or flatten box under it if working on a rough surface to protect the scooter. Then used the supplied Allen wrench or similar object by putting the long end of the wrench into thru the opening hole on the other side of the wheel. Wedge the edge/end of the wrench against the value from the other side of the wheel and push hard to loosen up the value. This takes some time. Do this on both sides of the value and also against the center of the value. It took me about 5 mins of careful pushing. Eventually you will be about the get the value to almost a right angle from the wheel and sticking out about and inch. Then remove the plastic cap. This will give you room to attach a bike pump. I actually had to push the value back in a bit once finished so the wheel could turn freely. It will work, just be patient and forceful. Take your time.

The Switch can be almost any but the lighted switch has to be a compatible 24vdc lighted switch. As seen on this web page. SWT-105 Razor E100 and E125 Electric Scooter Parts ElectricScooterParts com

Find out whether it is 6 volts or 12 volts and there should be two wires that feed the motor either cut or splice and attach another set of wires with fuse in the line (simular to jumper cables) raise the back tire so it does not touch the ground and place jump wires to the negative and positive of the battery.
If the motor moves in either direction without blowing the fuse the motor is good if not then its bad. Uses the same amperage fuse

replace the fuse with a bulb of the same voltage rating like 12v bulb it will take the spikes but it might allow her to over load it too an motor git warm then the thermalfuse might kick in . worn out motors an batteries do this stuff

Razzor was purchased by Polaris, contact nearest Polaris dealer

Change the motor or the pulley

hooperimports.com/showpages.asp?pid=1013
they have wiring diagrams and information on how to wire chinese import engines and for more info contact http://tinyurl.com/m7ghqz

Hi:
I have a rascal 3 wheel chair and the tire is flat on back, how do they come apart for repair, thanks.
Leroy

Razor E100 batteries are easily replaced & there are guides on how to this on razor.com, genuine Razor batteries are available at most good Razor product stockists.

if your gonna write something that can't be answered atleast accept me so i get paid for my time unless you can explain in detail what your problem is

using a Normal bicycle pump