Razor Popular Questions, Answers, Tips & Manuals

use a multimeter and check that you are getting power to the motor

Usually that means the battery is not able to hold a charge.

yes! if that's the case ,the motor is the culprit.there are 4 things that make our bike run..the a good charger, batteries, the throttle, and the motor. now that you singled out your battery and charger ,you have the throttle and your motor..1st check your throttle & make sure it stops @ a1/4 twist.check all connections, then do an extencive check of your motor for moisture or water/signs of it being wet/riding in the rain..which is a big No-No../no rain No snow, No drizzle,and no puddles clean or muddy..it is not a gas bike....remember!great tip!

i have a razor 175 but it doesent work.i just got it yesterday and charged it the whole night.it turns on fine but all it does is it just click but doesnt run.can somebody help me?

Sounds like the batteries are low in capacity and need replacing. The batteries do not last well if left sitting (hardly used).

shake the batteries if they sound like they have sand in them, then they are dried up and need to be replaced

the user manual for the Razor MX350 is available on the web.here http://manuals.monsterscooterparts.com/recreational/Razor/ it shows how to remove/install the rear wheel.

test the motor with your own battery. connect the battery directly to the motor if that work is the controller, easy.

user manual is here http://www.electricscooterparts.com/manuals/razor-mx350-mx400-manual.pdf

It is not designed to charge while the power switch is on..you will damage your bike and void your warranty.thats like putting the positive and negitve on backwards when u jump a car...don't do it, follow instructions...

You threw away a perfect scooter you idi0t. Needed to desulfate battery with a smart charger. M0ron.

Here is the owners manual for the future (in case you don't have one.)http://www.meijer.com/assets/product_files/pdf/1000422_groundforce_manual.pdfIt sounds like the push button fuse next to your charging plug. Push that in and try again. Otherwise it could be a wiring defect.

yes .stop playing with the connectors...but that do tell urself that is a future problem

i bought a new battery for my toyota remote control but it doesn't work?

Check that the lights on the throttle battery gauge show green. Lift the rear wheel off the ground and apply throttle and watch the lights. If the battery voltage drops under this load, indicated by the light changing to yellow or red, then it is likely the batteries are low in capacity and need replacing. Most battery shops will load test the batteries free of charge to confirm. If the batteries test OK then it may be a bad connection between the batteries, fuse, switch and controller may also cause the voltage to drop under load,

Where is the noise is coming from - front, back, left or right side?What sort of noise is it? Does it only make the noise when the motor is running or also when the bike is wheeled with no power?It could be there is debris caught in the drive train or brakes. The brakes may need adjusting or the drive train may need lube.Have a look at the owners manual and trouble shooting guide here http://www.razorama.com/razor-installation-guides.html

remember the motor transfer the power to the front..there no weight on the motor when you take it off..the motor can be going bad/a singnal! most people change the battery without checking the motor for wear..

Check all the connections. Purchase a replacement throttle assembly. I’m happy to help further over the phone at https://www.6ya.com/expert/joshua_ac64e182ed26f66d

Have a look at the Trouble shooting guide herehttp://www.razorama.com/razor-installation-guides.htmlThe wiring diagram can be down loaded here http://manuals.monsterscooterparts.com/recreational/Razor/Wiring/ the owners manual can be down loaded herehttp://www.razorama.com/razor-owners-manuals.html

check for loose connections on battery or replace battery