Razor Cycling - Answered Questions & Fixed Issues

A green light means the battery is charged.

Question edited for a lot more clarity. Question moved from 'Power Computers' to model category. Did you just remove the lead acid AGM batteries and replace with Lithium Ion? There is a lot more to it that that, you have to replace the controller as well and for safety you need a LiFePO battery and a new twistgrip because the old one is little more than an On / Off switch.. Motor Controller Kit 24v LiFePO4 Battery Lights and Horn Kit https://www.ebay.com/itm/222627137235

Here is the link. Watch it.

Question edited for clarity. There are some ideas here. If they don't work, contact Razor Support. https://www.google.com/search?q=mx+500+razor+solenoid ..

Hi,
Look at the connector end that plugs into the bike. You might have to take it apart to see the wires inside. My son has a Razor Vespa type scooter and the solder job for the wires inside the connector were not the best. It might be a broken wire, especially if it's flashing between red and green.

Hope this Helps!
Please Rate;)

Gary

Have you tried removing plastic chain guard and making sure chain is not off track i had this problem and that is all it was.

are the chain and sprockets worn out?

SHOULD BE A RETURN SPRING ON IT

I think you can a new dirt bike charger easily on Amazon or on the razor website. Be aware of how you use the battery though, it is the same idea for a lot of mobility equipment (electric scooters, electric wheelchairs, electric bikes, and etc...). You need to use the battery PROPERLY. For example, charge them from time to time, don't leave them there for a long period of time just because you don't need to ride out your electric dirt bike. Your battery's longevity will get hurt. Also, protect it from water and dust. I learn a lot more about outdoor sports equipment on this site: https://mobilityseeker.com/.

I suggest you call a razor customer service person.

How do I charge a Razer zr350 dirt bike without a charger

Thoughts - No/poor connection between power source and motor Motor failure Only someone with their hands on the bike can fully diagnose.

Hi, You'll need to remove the keyswitch itself & either take it to a locksmith to have a replacement cut from the barrel or replace the entire keyswitch with a compatible replacement unit.!

Either the cheap lead acid batteries are near dead (mostly due to improper maintainance (lead batteries are way too much trouble and lithium should be considered!) There could be a loose or corroded connection - check on all your wiring, especially the ones to the motor. Also where it goes into the motor is fragile and people bump that area and it rips the wire, there is a steel spring that surroiunds the wire/s and this sometimes shorts out because of the damaged cause from laying the bike on it's side. check these wires over and tug on the connector wires to find the weak connection. Also verify that your charger turns red indicating it is charging when attempting to charge the bike, if it stays green chances are a dead battery or BMS controller inside battery (Lithium only!)\ Most repairs are very simple if you take the time to check out the connectors and wiring, especially if you use it in bad weather, things get corroded from being wet and power shorts out then corrodes the wires and connectors. Good to insulate them for the rain etc... Think Im on the right track here, and i have many ebike because people dont know how to fix simple issues with a tester.

it is a old charger ?

The off and on switch lights up but will not start.

DOES THE BIKE HAVE A FUSE CONNECTION BEFORE THE CONTROLLER? IF IT DOES THEN I WOULD LOOK FOR THE FUSE LINE AND IF IT DON'T THEN I AGREE WITH YOU'R ASSUMPTION.IF AND WHEN YOU DECIDE TO FIX IT,I WOULD CONSIDER A FUSE I'LL BE LESS $$$. D,R,CLAUDIO

this is a little complicated. 1-check fuel line and filter make sure you have a good gas flow. 2-check you'r hose's for leaks 3- OPTIONAL -check you'r engine for compression.you can buy a pressure gauge at auto zone buy the one that screws into the piston hole it makes it easy for you. REMINDER!! IF CHECKING THE FUEL LINE AND IF IT RUNS BETTER OR BY CHECKING THE HOSE'S AND IF IT RUNS BETTER (THEN YOU WON'T HAVE TO CHECK ENGINE CHECKUP THIS OPTIONAL.) SAFETY FIRST GOOD LUCK. D,R,CLAUDIO

BEST SOLUTION GO TO A GOODWILL MOST OF THE TIME THEY HAVE- BIKES FROM $10.00 TO $40.00 AND YOU LOOK FOR A BIKE THAT HAS A GOOD BACK WHEEL AND YOU'LL HAVE EXTRA PARTS HERE IS A LIST OF PLACES GOODWILL&THRIFT STORE& SWOPMEET THAT HOW I FIX MY BIKES.. HAPPY HUNTING. D,R,CLAUDIO

I think you are talking about an electric motor on your bike . If the motor is New you may have a bad throttle switch . You can use an ohm meter to check the throttle switch . Connect the two leads of the ohm meter to the wires of the throttle switch ( dissconected) . As you turn the throttle the ohm reading should coraspond to how much you turn it .