I need replacement keys for
They best thing to do is try to find a broken one on Ebay, they run around $24. I did a search for websites that sell just the keys and couldn't find any. You may be able to steal a key off another type of keyboard, but without knowing the type of mount your keys have I can't be positive that will work. The Lycosa Gaming keyboard, or any specialty gaming keyboard, will be very hard to find specific parts for.
Also, check too see if you have a keyboard withing the serial numbers posted on this website. It looks like they are recalling and replacing some of the keyboards they sent out due to defects.
Link:
http://www.techpowerup.com/index.php?85841
Moray Plus Microphone
Look in control panel and look for add new device or software go into that and try adding the earphones like that if not try taking them back
My mouse isn't moving on the screen
Hi I had this recently do you have a small oblong button right below the spacer bar you might have pressed it by mistake, while dusting etc, this freezes the pointer, also on my previous laptop I had the same problem but no button, so that was fixed by closing it down, unplugging it, removing the battery and replacing then switching back on, very important though to unplug from the mains......
8/27/2012 9:39:13 AM •
Razer...
•
Answered
on Aug 27, 2012
I can't hold on with left mouse button.Please
I had the same problem. I took it apart and cleaned it. The screw is located at the rear of the mouse in the center. It is underneath the bar code. It is a triangle screw but I was able to get it apart using a standard jewelers screwdriver. I cleaned the top and dusted out the inside. Now it works fine.
How do I tighten a loose earpiece?
The whole thing is probably plastic and subject to breakage if you're not careful. I've found that gentle pressure on plastic pieces works most times. But--that's the trick. How to get just the right pressure. I'd sure try it, but be careful. Glueing that type of plastic is very difficult. It can be done, usually, by melting the pieces together with lacquer thinner.
Not finding what you are looking for?