Quickie Wheelchairs Recent Questions, Troubleshooting Help & Support

Leave it plugged in for 2 days. It'll probably begin charging by then. If not,check connections. At the battery and the line.

VSI Code 8: Controller Error...

You got some bad batteries or your charger is not working. If Medicare purchased the chair contact Repair Xpress at 1-877-581-3733 Medicare will pay for most of the repairs

Hi this is usually what occurs when the batteries are failing, much like a car battery as they age they charge fine but the amount of stored power is gradually reduced till eventually it will no longer start the car

Make sure the chair is not in freewheel mode. Also just because the batteries read fully charged does not mean that they are "good" batteries. Have them load tested. As far as the reset button, the normal positon is pushed in.

Since you already know what kind of nut you need, go to the local bolt supply house and get a nut. I would think you could also order the parts online for the chair.

Quickie Wheelchairs com Southwest Medical Home

Hello. Here is a link to the parts dept. of your chair's manufacturer
http://www.quickie-wheelchairs.com/wheelchair-parts/sunrise-medical/breezy-ultra-4/base-frame/frame/hemi-frame

Joe

1. With the VSI powered on, press and hold the on/off key. After one (1) second, the VSI should beep.
2. Release the on/off key.
3. Push the joystick to the full forward position until the VSI beeps.
4. Pull the joystick to the full rearward position until the VSI beeps.
5. Release the joystick. There should be a long beep.
6. The VSI is now locked.
To unlock the VSI:
1. Press the on/off key and power on the VSI. The maximum speed/profile indicator should ripple side to side.

NO manufacturer has an assembly guide as all the chairs are shipped assembled, or mostly assembled. Most have battery replacement guides and other minor issue stuff, but nothing to take the chair fro womb to tomb.

Press and hold power button til beep then push joystick forward and hold joystick til beep then pull the joystick back and hold joystick til beeps. turn power off then on. should be unlocked now