Psi Tools & Hardware - Others - Page 8 - Recent Questions, Troubleshooting & Support
My PaperPro One finger 15 sheet power Stapler just stopped stapling. ???
For PaperPro Prodigy. Best stapler I have used but after about 8 years the flat steel staple driver broke. To repair, remove the bottom by forcing it back, force the stapler halves apart with a flat screw driver and the top comes off. The springs and levers are on one half and they will not fly apart. I couldn't find the staple driver part (on the left) so go to the store and buy a new stapler.
Drying out wet drywall
I'm assuming your talking about drywall that was wet during a flood of some type? Recommend you remove all damaged drywall and using a straight edge and a utility knife this can be easily accomplished. After you cut and remove the damage, remove all screws or nails from the studs giving a good surface for the new drywall that your going to replace the damaged stuff with. Get that done and we can move onto taping and drywall compound repairs. Hope this helps.
Can’t get staple to come out
Didnt give much info to go on lol. Make /model and a little more detail on your issue will be needed before anyone can try to help you
How do you load a Arrowv nail master 2 et200 brad nail gun?
LOADING NAILS
* Disconnect the tool from the power source when loading brad nails * Tilt the tool or lay the tool flat, so the nails will not drop out while loading
*Press lever (A) while pulling slider (B) backwards Place the nail strip into magazine (C) (maximum capacity 100 nails)
Can you tell me where to get a manual for my AMT shaper/router model 4750?
Apparently AMT is no longer in business. There may be a similar Craftsman model in case a manual can be located for it, but link below suggests they did not locate manuals.A Craftsman shaper from the 1970's manual for sale: https://ozarktoolmanuals.com/machinemanual/craftsman-wood-shaper-113-23930-owners-instructions-parts-manual/You might try posting a forum request on the following site, in case anyone c an assist.http://vintagemachinery.org/mfgindex/detail.aspx?id=29&tab=3
https://www.shopyourway.com/questions/1192269
Guardian Power FDM16 sp drill press binds when trying to lower bit.
by first engaging the quill lock (or blocking the quill in place), then removing the nut over the center of the spring housing opposite the quill handle, but be very careful; The spring is under a lot of tension, and if broken or jarred, it can fly out of the housing, causing serious injury. I'd strongly suggest you find a service manual for it before attempting any repairs or adjustment. The fact that the quill is binding leads me to believe that the spring is set improperly, which might be remedied by carefully (slightly) loosening the nut, thus allowing you to rotate the housing, allowing a small amount of tension at a time to be removed from the spring, until desired operation is achieved. In any case, no attempt should be made to remove the housing until the spring tension is safely relieved. The procedure is very similar to that for a bridgeport mill, so that manual for quill (clock) spring adjustment/replacement might be of use to you also.
Not finding what you are looking for?