Proton Televison & Video - Page 5 - Recent Questions, Troubleshooting & Support

0helpful
1answer

It just wont stay on it goes on and off

i have a envoy 2007 i have to check the voltage of ignition coil how much it should be each cylinder.
4/30/2010 8:39:28 PM • Proton MM2701VT... • Answered on Apr 30, 2010
0helpful
1answer

My tv quit with no picture or sound and only a white line

It's more than likely that the white line is from left to right, is that the case?
4/17/2010 4:37:17 AM • Proton MM2701VT... • Answered on Apr 17, 2010
0helpful
1answer

I have a problem with

Hi,

I am Sorry to Hear regarding the Problem. Unplug the Unit for Few Minutes, say 15 Minutes and then Turn it ON. Do you still see the Problem?

Have you tried to Run DVD Player. If not Use it and Check, if that is still the Case?

If Yes, this is an Internal Failure and You need to Open the TV to get it Resolved.If you wish, you could Contact a Local TV Repairman to get it Resolved or let me know the Make and Model and i would be able to Guide you.

Make sure to take all the Precautions and all the Security Measures.Also, tell me How Old the Unit is?

Make sure that you need to have Tools like Multimeter and Magnifying Glass and you need to have the Schematics ( We could also Search for Cost effective Service Manual, if that is available with any Vendor ).

Let me know,so that we could Proceed.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!
4/6/2010 12:15:35 AM • Proton Televison... • Answered on Apr 06, 2010
0helpful
1answer

My TV turns itself off immediately 42

There can be several causes for this, few of which you can do anything about. However, a few things to try:

1) Replace the batteries on your remote control.
2) Try resetting the logic functions on your tv by unplugging it for a minute, then plugging it back in.
3) Try covering up the infra-red receptor on the front of your TV to see if you're getting unwanted signals from the receptor. taping a piece of foil over that area is perfect. If it doesn't stop after doing these two things you'll probably need to take it to a shop.
4) If this does stop it, then look for unexpected signal sources. Have you added a remote control extender? Added a new device to your audio-video system? Changed to a new remote?

I hope this helps. Joe
3/31/2010 12:24:18 AM • Proton MM2701VT... • Answered on Mar 31, 2010
0helpful
1answer

Lost paper with codes!! need code for sanyo tv

017,023,027,038,066,080,091,098,123,125,126,202,203,205,206,207,208,209,210,211....hope this helps..
3/18/2010 3:58:25 PM • Proton MM2701VT... • Answered on Mar 18, 2010
0helpful
1answer

Sony KDF-E55A20 picture and sound goes off and on.

i can't understand!!!!!
3/18/2010 12:28:47 PM • Proton MM2701VT... • Answered on Mar 18, 2010
0helpful
1answer

My kids messed with the color..is there a factory

Yes, push the menu button on the remote and scroll through the menu items until you find the color adjustments. Joe
3/10/2010 12:07:12 AM • Proton MS-42 LCD... • Answered on Mar 10, 2010
0helpful
1answer

Hello, I have intermittent audio. It is silent

rgb blek and wiat

3/2/2010 1:29:03 PM • Proton MM2701VT... • Answered on Mar 02, 2010
0helpful
1answer

I want to buy a

2/9/2010 10:19:54 AM • Proton SRC-2010... • Answered on Feb 09, 2010
0helpful
1answer

When i press the button on the tv flash a blue

Power supply is dead.Must replaced the power supply board.
2/8/2010 3:36:29 AM • Proton MM2701VT... • Answered on Feb 08, 2010
0helpful
1answer

My rca tv turns on and off by itself,whats the

Power supply is dead.Must replaced the power supply.
2/8/2010 3:32:29 AM • Proton MM2701VT... • Answered on Feb 08, 2010
0helpful
1answer

My remote won't power on and won't turn up the

You need to test your remote separately. The easiest way to do this is, get a video camera either a mobile camera or a separate VGA/Mega camera.
Switch on / activate it and put the remote control in the camera so that you can view the front lens of remote in the camera. Now push each button one by one and you must have to see a light emitted from that sensor (IR LED). If all button emit light as you see with your camera then its a proof, the remote is OK.
Hope you understood what i tried.
Don't hesitate to ask further, if required.

good luck
1/26/2010 3:02:31 PM • Proton MM2701VT... • Answered on Jan 26, 2010
0helpful
3answers

Our Spektronik PLTV3250 television remote

Hi

There is no Point in getting the Remote repaired as the cost of Repair would be much more than the new remote. Yes, Original Remote is not available.The substitute remote is :-

http://remotes.com/store/protron/pltv3250.html

Is that the same one you purchased? Have you programed it correctly?

It could be an issue with the TV. The IR sensor which senses the signal from the remote might be Defective.

Let me know, if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!
1/24/2010 4:33:08 PM • Proton Televison... • Answered on Jan 24, 2010
0helpful
1answer

My samsung keeps turning on and off why?

The power supply board has failed and needs to be replaced. You can call 1-800-samsung to find nearest service center.
1/13/2010 10:38:08 PM • Proton MM2701VT... • Answered on Jan 13, 2010
0helpful
1answer

I want to buy a

Hi,

The original Proton SRC-2010 remote control is no longer available. However, you can purchase a substitute remote control which has similar functions.

To view the features and more details of the substitute remote, click on this link.

Also, you can call on 1-800-736-6837 to get more details.

Hope this solves your problem. Thanks for using FixYa.
12/9/2009 8:04:47 AM • Proton SRC-2010... • Answered on Dec 09, 2009
0helpful
1answer

My 15 yr old panasonic tv turns itself on and off,

My thoughts is that after all these years one of the solder joints has cracked and there is enough current that builds up that it will jump accross the crack and work for a short time and then the componenet heats back up and 'well' off it goes.
15 years old. - you got some great use out of this TV.
Maybe time to look to get a new one - These types of TV's were only designed to work for 10 year and then throw them away. Be aware that the new ones are only made to last 3 to 4 years. I know - I don't like it either. They cost a lot more than that Panasonic did when it was new.
Blessings,
A/V Media Guy
11/22/2009 4:46:07 AM • Proton MM2701VT... • Answered on Nov 22, 2009
0helpful
1answer

Hi there, my new 60

try relocating it to a different power source. like a different room. problem could be small drop in 110 voltage. like when your refrigerator comes on or your air conditioner comes on. they could be on the same 110 line. there is a circuit that senses incoming voltage. if voltage drops too much too quick, the protection circuit shuts tv off. to protect. could be down the street from you. your set is fine
11/13/2009 3:01:45 PM • Proton MM2701VT... • Answered on Nov 13, 2009
0helpful
1answer

I have a Mitsubishi 50in TV I turn it on it runs

the light engine is going bad. take the set in for service. and hope its under warranty. good luck..
11/12/2009 9:10:08 PM • Proton MM2701VT... • Answered on Nov 12, 2009
Not finding what you are looking for?
Proton Logo

144 questions posted

Ask a Question

Usually answered in minutes!

Top Proton Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1259 Answers

Bob Kirkwood

Level 2 Expert

175 Answers

Larry

Level 3 Expert

5042 Answers

Are you a Proton Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...