There is a VERY complete tutorial on how to remove your oven door for hinge replacement or just for cleaning at https://www.youtube.com/watch?v=6YFTYWsiO1M
The narrator is clear spoken and the instructions are easy to follow not to mention the fact that you can go back to it any time for a refresher if you need to. Most ovens are very similar in how the doors work so this should do the trick.
then watch the next one for the cleaning directions
https://www.youtube.com/watch?v=GP2OC-NwxYU
I would add that you might want to wear rubber gloves. As a 5' woman I found that the oven door was a little heavy and the extra grip is handy. Be sure to have something ( like a small coffee table) to set the door on as soon as it's loose to prevent back strain.
When you wire the transformers you need to make sure the power for both transformers are coming off the same leg of power from the main panel box. If you don't you will burn one or both out.
They do sell kits that you can buy to parallel wire both transformers. You can also power both transformers from one furnace. Do a search on youtube and you should be able to see how it's done.
do you have to press a button to ignite? water has in.
If it is in the oven then its different. The igniter is always trying to light the oven when the oven is on. You dont get a spark because the flame conducts electricity. if there is no flame, then you get a spark which lights the gas again (Clever init). So you either have a bit of dirt which is stoping the flame going between the two electrodes or the electrodes have got knocked and are not in the flame.
Hi the HP Laserjet CM6040 how to reset the document feed roller go to administration then go to reset menu then in reset menu scroll down until you see the new document feed roller select either yes or no. Hope this helps
Make sure that your power unit is operational and that you or whoever installed the power unit properly and connected all connectors inside the computer in their right place
The rust can be from rusted pipes, and not necessarily tank:
New tank has new anode rod, and is NOT likely to be cause of problem.
Anode only protects the tank... not your steel pipes.
There are mathematical formulas for figuring what size and type anode is needed for steel structures like bridges and water heater and boat hulls... if anode is too small or deteriorated, or coated in calcium, or not electrically bonded to the steel surface, or if tank is not full of water or boat hull is out of water, then anode cannot protect the steel.
For more insight about problem:
http://www.thetankatwaterheaterrescue.com/forums/forum3/http://waterheatertimer.org/Replace-anode-rod.html
Gene h
If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7
If nothing whatever happens when you turn on - no lights, no fan noise then the power is not getting through. This could be a dud power socket (but I guess you checked that). The on/off switch usually isnt! It is lonked to a relay switch and the link may have failed, or the relay failed. Or else of course a power supply failure.
do you hear any clicking when you try to start the oven portion of the range? if not lets try this, open the lower drawer so you can see the burner bar and mechanism for lighting the bake bar. as your watching the mechanism turn on the oven (nothing should happen as per your issue) while oven is on try lighting one of the top burners, any one will do wanna check if that lites the spark and in turn lites the oven pilot.if that does infact work you have a bad spark switch for the oven control