Precor Exercise & Fitness - Page 9 - Recent Questions, Troubleshooting & Support

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH The following link is to the service manual for the Precor 9.23 treadmill. http://www.sportsmith.net/images/product_support/precor/Service%20Manuals/Consumer%20Treadmill/9.23%20(serial%20code%20AXGA,%20AYYA).pdf

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH Precor Error LS, Speed Sensor Signal Missing Probable Cause 1. Intermittent or open connection of the speed sensor (reed switch) wiring. 2. Reed switch is defective or has intermittent connection. 3. Drive motor brushes are bad. 4. Lower PCA is bad. Corrective Action

1. Inspect the speed sensor (reed switch) wiring for damage or poor connection to the lower PCA. Replace damaged wiring or reset connection as necessary.
2. Using an ohm meter, test the reed switch while rotating the drive pulley. The reed switch will close when the magnet passes in front of it.
3. Inspect the drive motor brushes and replace if necessary.
4. Test unit with a known good lower PCA. Replace lower PCA if necessary.

Precor Error Code LS

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH This sounds like you are dealing with a bad upper display board.

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH You can find the diagram for this model by using your model and serial number at the following link. Repair Parts for Precor C954i Treadmills 120VAC 240VAC SPORTSMITH net

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH The max user weight is 350 lbs.

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH Typically this is caused by a bad pillow block bearing. I would suggest trying to pin point the sound a bit better, but this is common of the pillow block bearings. Precor Parts for EFX 554i 556 556i Ellipticals SPORTSMITH net

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH Warning Notice for Battery Installation of certain Precor Ellipticals This notice provides details about the battery replacement procedure that should be considered by anyone performing this repair. Following is the warning about the battery installation for certain models of the Precor ellipticals.

Precor Elliptical Models Affected:

• EFX C524 with serial#s beginning I7, K7, LH, SW, SX
• EFX C546 with serial#s beginning NF,SZ, IK, IL, IU
• EFX C546I with serial#s beginning X8, XG, Z2
• EFX C556 with serial#s beginning NG, SY

When replacing the battery on your Precor elliptical it is important to make sure that the battery terminals are not allowed to make contact with the metal surface of the battery bracket. **Damage to the battery will occur**. Electrical tape can be wrapped around the battery terminals to prevent them from making contact with the metal surface of the battery bracket. Battery replacement on the EFX C524, EFX C546, EFX C546i and EFX C556 instructs you to remove the (4) screws that fasten the battery bracket to the frame. This allows you to turn the lower PCA and battery assembly away from the frame so you can slide the battery out of the battery bracket. It may be necessary to remove the nut that fastens the front retaining bracket or "L" bracket in order to slide the battery out of the battery bracket. Warning Notice for Battery Installation on Precor EFX Ellipticals

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH This is commonly caused by a bad overlay/keypad. The only solution to resolve this issue is to replace the overlay/keypad. Please use your model and serial number to find the correct replacement at the following link: Precor Equipment Repair Parts Treadmill Belts Ramp Sleeves SPORTSMITH net

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH You should start by inspecting the brushes inside the motor. If these are worn, which is common over time, then the motor would start to lose power. The following link will take you to a motor brush. Be sure and have your complete model and serial number available to confirm the brush is compatible. Motor Brush Pac Sci YP00521 Each Precor PPP000000020002112 SPORTSMITH net

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH Warning Notice for Battery Installation of certain Precor Ellipticals This notice provides details about the battery replacement procedure that should be considered by anyone performing this repair. Following is the warning about the battery installation for certain models of the Precor ellipticals.

Precor Elliptical Models Affected:

• EFX C524 with serial#s beginning I7, K7, LH, SW, SX
• EFX C546 with serial#s beginning NF,SZ, IK, IL, IU
• EFX C546I with serial#s beginning X8, XG, Z2
• EFX C556 with serial#s beginning NG, SY

When replacing the battery on your Precor elliptical it is important to make sure that the battery terminals are not allowed to make contact with the metal surface of the battery bracket. **Damage to the battery will occur**. Electrical tape can be wrapped around the battery terminals to prevent them from making contact with the metal surface of the battery bracket. Battery replacement on the EFX C524, EFX C546, EFX C546i and EFX C556 instructs you to remove the (4) screws that fasten the battery bracket to the frame. This allows you to turn the lower PCA and battery assembly away from the frame so you can slide the battery out of the battery bracket. It may be necessary to remove the nut that fastens the front retaining bracket or "L" bracket in order to slide the battery out of the battery bracket. Warning Notice for Battery Installation on Precor EFX Ellipticals

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH Start by checking the voltage output from the battery. I am attaching a link to a video with instructions on how to test a battery. Video about How to Test Battery

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH Warning Notice for Battery Installation of certain Precor Ellipticals This notice provides details about the battery replacement procedure that should be considered by anyone performing this repair. Following is the warning about the battery installation for certain models of the Precor ellipticals.

Precor Elliptical Models Affected:

• EFX C524 with serial#s beginning I7, K7, LH, SW, SX
• EFX C546 with serial#s beginning NF,SZ, IK, IL, IU
• EFX C546I with serial#s beginning X8, XG, Z2
• EFX C556 with serial#s beginning NG, SY

When replacing the battery on your Precor elliptical it is important to make sure that the battery terminals are not allowed to make contact with the metal surface of the battery bracket. **Damage to the battery will occur**. Electrical tape can be wrapped around the battery terminals to prevent them from making contact with the metal surface of the battery bracket. Battery replacement on the EFX C524, EFX C546, EFX C546i and EFX C556 instructs you to remove the (4) screws that fasten the battery bracket to the frame. This allows you to turn the lower PCA and battery assembly away from the frame so you can slide the battery out of the battery bracket. It may be necessary to remove the nut that fastens the front retaining bracket or "L" bracket in order to slide the battery out of the battery bracket. Warning Notice for Battery Installation on Precor EFX Ellipticals

Precor Error 29, Excessive AC Input Current Probable Cause 1. The running belt and/or deck are badly worn. 2. Bad lower PCA. 3. Drive motor is shorted or de-magnetized causing a high power demand. Corrective Action

1. Check the amp draw using a clamp on AC volt-amp meter during loaded and no load conditions and compare values to a similar treadmill that is known to have a good running belt and deck. Replace the belt and/or deck if necessary. Don't forget, some units have a double sided deck which means it may be flipped over rather than replaced if it has an unused side.
2. Test unit with a known good lower PCA. Replace lower PCA if necessary.
3. Test unit with a known good drive motor. Replace drive motor if necessary.

Precor Error Code 29 Replacement Parts for Fitness Exercise Equipment at SPORTSMITH

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH You can find the overlay and keypad on our Website, using your model and serial number.

Hi, Internal memory: approx. 14MB, SD memory card

A treadmill will shut down from to much friction which is due to high motor current because the walkbelt and deck are not properly lubricated. I would recommend replacing the motor controller,walkbelt,deck and applying .5 oz of lubricant on the deck every 3-6 months or 100 hours of use. This will extend your treadmill's life many years.

It doesn't always say low battery - check the battery first. If the battery is fine, then check the lower board and the incline motor. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/russell_1d1c35fa8a5a0be4