Pramac Electrical Supplies - Page 6 - Recent Questions, Troubleshooting & Support

0helpful
1answer

How to change oil in pramac gsw 50kw towable

If you have a Yanmar engine...There is a hose that is connected to the oil pan in place of the drain plug directly under the oil filter that will have an end cap. This hose is used to drain the oil into a waste container. Download the service manual located at the address below and follow the instructions in the manual. http://www.martindiesel.com/Documents/New%20TNV%20DIRECT%20Service.pdfHope this helps.
8/22/2013 9:50:26 AM • Pramac... • Answered on Aug 22, 2013
0answers
0answers

Change oil

Be the first to answer 8/14/2013 5:15:50 AM • Pramac Storm... • Posted on Aug 14, 2013Be the first to answer
0helpful
1answer

My generator it's not starting

FIRST THINGS FIRST. VENTILATED AREA,FRESH GAS, OIL LEVEL. IF ITS BEEN SITTING FOR MORE THAN 2-3 MONTHS THE CARBURETOR IS SUSPECT TO HAVE VARNISH PLUGGING JETS. START THERE. DARIN
8/2/2013 6:56:03 PM • Pramac... • Answered on Aug 02, 2013
0helpful
1answer

I have a pramac p6000 where the revs die off every so often.

fuel filter?
7/15/2013 10:07:42 PM • Pramac P6000... • Answered on Jul 15, 2013
0answers
0helpful
1answer

Low power

Hi ,
firstly i would do a full service on it , all filter and fluids , oil/coolant water,fuel filter(s) and air filters
pay attention to any water seperators , check all fuel line connectors and unions are tight and in good order ( drawing a small amount of air into the fuel system if often the cause of ''a lack of power '')
check your diesel as it absorbs moisture and can severley effect the running of an engine .
if this has no effect
get a rag /goggles and the right size open ended spanner and slacken each fuel injector nut whilst the engine is running , listen for the engine noise going down , if it dosent this means the injector is deffective ( might need replacing or cleaning ) do this to each injector in turn , be very careful as you do this , the diesel is at 200bar pressure and can injected you ( hence the rag )
a final one is the fuel lift pump may be deffective , they often partially work and starve the engine at maximum revs , depending on your engine this will be an electric one or driven directly from the engine block , just follow the fuel lines from your diesel tank ,.
hope this helps


6/4/2013 8:53:02 PM • Pramac GBW30P... • Answered on Jun 04, 2013
0helpful
1answer

Phase voltage is not same

What is your problem and what is the question?
4/17/2013 12:49:08 AM • Pramac... • Answered on Apr 17, 2013
0answers
0helpful
1answer

5000s diesel will not start even on ether

mmost engines have a low oil switch. if generator is not level or it is low oon oil by just a little it will not start hope this helps bob
3/4/2013 7:25:41 PM • Pramac Diesel... • Answered on Mar 04, 2013
0answers

Sd under speed

Be the first to answer 11/18/2012 9:35:14 PM • Pramac... • Posted on Nov 18, 2012Be the first to answer
Not finding what you are looking for?
Pramac Logo

167 questions posted

Ask a Question

Usually answered in minutes!

Top Pramac Electrical Supplies Experts

littlewheel

Level 2 Expert

122 Answers

Ngoro

Level 3 Expert

3521 Answers

john h

Level 3 Expert

29494 Answers

Are you a Pramac Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...