Powerware Recent Questions, Troubleshooting Help & Support

I have a unit I'm parting out. Bill - 5086797432

relay not work

Did you use quick-connects on back of device?Copy following link for wiring illustration:http://waterheatertimer.org/images/Wire-2-outlets.jpg If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

you have to check the I/P voltage , the face rotation , THR. of rectifire , IGBT ,driver of the IGBT

Most follow the reset procedures to reset from a EPO shutdown. Usually it is a fuse on Powerware that needs to be pushed back in.

Direct current will always run even if batteries are dead. Batteries only kick in during a real outage. Is this what you are referring to?

The charger in powerware 9 series 9120 6000i ,the fan is of a quality that it fails and the heat sink does not get sufficient cooling ,it runs on 12 volt ,i replaced it with a cpu fan from a mainboard on a pc and it works perfectly now. make sure that the fan is running else the charger might go in protection or can fail due to the transistor on heat sink fails.