Powermax Air Tools & Compressors - Recent Questions, Troubleshooting & Support
I am replacing the engine
normally it would not be pressed on as it would tend to bent the crank. It may be tapered and keyed and rusted on or it may be straight and keyed and rusted on . You may have to use wd-40 to release the rust or a puller and heat to get it off.. The impellor may be screwed on and may just require a tap to start undoing it.
Can this pump handel solids
Trash pumps will handle any solids small enough to get through the intake hose screen. This usually means most mud and sand and other debris. If you take the screen off the intake hose you run the risk of sucking up too much solid material and overwhelming the pump or sucking up items too big to get through the impeller. Sticks are also a no go through these pumps. If they are small enough to get into the impeller they'll get chewed up but usually they get stuck in the hose attachment area and create a dam for everything else coming up the hose.
I BOUGHT A PUMPSET ABOUT
If there is a leak in the pump then please check if the leak had come from the drain plug or the inlet. If the leak is elsewhere it is important to get in touch with the dealership and get explanation.
The starter cord will not
Remove the spark plug and try again, if this works continue to pull until the cyclinder is clear of all fluids. Then make sure your oil level is topped off.
Pump will not pump water
I would have a check valve installed in the inlet line - Dont know if you have the manual, but pumps should be within so many feet of the water source, dependin on the suction capabilities. You probably have air in the inlet side, and if you don't have a check valve your pump may be too far away to pick up the water. You can always fill the suction side, and if you know for certain that you have water coming in, and the inlet isnt plugged up, you probably have a pump or driveshaft problem. hope this helps you, rick
I need a head valve seat for central pneumatic 21 degree angle framing nailer model 60828 also need headvalve seat for 34 degree angle finish nailer 68020
I have not been able to purchase replacement parts for these nail guns , however, have repaired them using parts from Bostitch framers and or just make the part. If the seal fits over the top of the cylinder, then try using seal from Bostitch framer part #N70155 fits a bit tight but works. Heat with a hair dryer to soften and install. If the seat is incorporated within the head valve, just dig it out and replace it with liquid two part urethane. Just mix and pour it in. After cleaning out the old seal, place head valve on level surface and pour in the mixed urethane till slightly over full to give the seal a nice crown. The finish nailer might also be repaired using other brand of seals. Remove the old part and take it to service center for a possible match. Good luck with your repair.
What oil should I use in Handiair H8/25 Compressor?
Many air compressors use a mineral blend or a synthetic oil, such as synthetic hydrocarbon, polyol ester or polyglycol. It is important to use a lubricant specifically rated for air compressors; do not use a general-purpose motor oil used for automotive or other purposes.
Read your user manual for more information.
Not finding what you are looking for?