Power Acoustik Answered Questions & Fixed Issues

Disconnect all speaker connections and rca cables. Leave power, ground and remote wires intact. Try turning on again. If you still have a protection light your amp is faulty. Hopefully you have warranty . .A thumbs up would be greatly appreciated if this answer is helpful to you

Going in and out sounds like the antenna cable got loose, but the not turning on sounds like the fuse blew. Worth checking those 2 things out first and foremost. Do you still have your owner's manual? If not: http://www.poweracoustik.com/pa2012/manuals/PTID-6250.pdf

Now you have a real problem. I hope you did setup a recovery mode for your Apple ID, because you have to visit the Apple page and ask them to send you a reset code, so you can reset your ID. It only works when you did setup this before. It won't work if you did not setup the security correct. Goto this page and ask Apple to help you. Follow the instructions. iPhone Apple Support

Hold the power button and the home button at the same time until restart.

It sounds like your laser or or other part in your CD/DVD has issues. There isnt much you can do to self repair it. Hopefully its still under warranty.

hi, you may run a disc cleaner for the optic lens might be dirty, hope this helps

Might be a dirty lens! Try a lens cleaner.

how random is it? Make sure the radio is grounded properly. Look in the pin outs in the harness and make sure there is a ground there. Also, you may have 1, 2, 3, or 4 bad speakers. A short in any one speaker will send the radio in protect mode. Also, If your radio is seeing less than something around a 3ohm load (technically 4) it will protect itself as well. I’m happy to help further over the phone at https://www.6ya.com/expert/chris_7f7f91eb941fb23f

You probably have on your car stereo either a single push button that you press to select the audio source (Radio/CD/DVD/Bluetooth) or 4 separate buttons labeled: Radio, DVD, CD, Bluetooth, respectively. Because a sync operation can refer only to a Bluetooth audio source (phone, tablet), your stereo is in now in the source mode for a Bluetooth audio source. Find the button or buttons for the selecting the audio source and select Radio or CD or DVD (you are already on Bluetooth).

I have a Digital Audio model-DA2200W, Was listening to my tunes loud as always....then the subs quit bumpin...checked the subs cuz i thought i blew em...theyre fine...The power on the amp is still on...green light and all..just no output..I opened it up to see if anything looked burnt looks fine...is it toast or can i fix it??

have u connectted the remote wire from head unit to turn amp on? have u got + and - the rite way round.hope this of use.

Make sure that the speaker wires are wired correct at both the amp and the speakers......otherwise it sounds like the typical death of a power acoustik amp (great amps, but prone to a premature death) I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_aad3edb7dfa380b9

Call Power Acoustik and tell them you had it for a few years and used it in a few cars so the harness has been chopped so short you need to get a new one. I'm sure if it was originally yours, they will want a receipt for the stereo brand new and they may sell it to you if it is available. If not, I sell new Soundstream Stereos at a very low discounted rate, as well, Power Acoustik. Check out the link below, we are the lowest price online for any of their products because we are closing all of the products out since they have driven the product line down to portray them as low as Dual and Craig., as a matter of fact, the products are all great, but, they do not protect their dealers and allow distributors to sell them online on Ebay, cheaper than the delaer's cost with free shipping, which has driven us away from them because we can't make a profit. Anyway, they should be able to sell you one, if not, give me a call or check our site, we sell their distributed products as well and may have a harness available on the website. Marc http://advancedelectronic.net/

If you're still looking for help I have the same one and had the same issue. You have to push the eject button once and right after push and hold it and it will let you change the angle. You have to be really quick between the push and push and hold. If it opens, just close and try again.

make sure you are using the correct impedance speakers and the speaker wires aren't grounded to the chassis in any way. If you are running more than one speaker per channel, make sure they aren't in parallel. If only running 1 speaker per channel, then it's likely a faultu speaker or grounded connection.

here is a site I'm not sure if it will work for your phone but you could give it try if you want to http://www.phonecruncher.com/how-tos/2235387/5_ways_to_restart_an_iphone_that_wont_turn_on.html

another couple of things is a bad ground wire. a sub going bad( causing a different ohm load then before) ive run into a bad fuse link in the amp before as well

I'm afraid the thing you call front glass is the tough screen once it is cracked you need it to be replaced. For an expensive and new tablet I would go to a phone store and ask them what it will cost. For an old or cheap tablet I would buy a new one. Anyway a replacement could cost up to 200 dollar. So don't forget to ask what it will cost in advance. Just to avoid surprises.

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. Do a search by type in the brand name of your device at its search box and press "Enter". http://electronicshelponline.blogspot.com/ Translation option is there by the right side pull up gadget bar.

Maybe the battery is bad