Poulan Measuring Tools & Sensors - Recent Questions, Troubleshooting & Support

1. incorrect mixture to much gas2 fuel line or bulb has cracked letting in air.3. Fuel filter in tank clogged

The problem that I had with my craftsman was that I found that there was a tube in the fuel tank that goes to the carb, & at the other end - inside the tank, there was a small screen with maybe a weight on it (to keep it in the gas no matter what position the weedeater is in). Mine was plugged up and i went to the saw shop and got a generic hose & end with the screen deal & changed them out. Solved my problem. Rick

check the compression on your weedeater low compression will cause this

the compression on a chainsaw can be checked by simply holding the crank rope by itself, it should chug down the rope very slowly.

http://www.managemyhome.com/mmh/lis_pdf/OWNM/L0804094.pdf

Check the spark plug /replace

I have a older poulan weed eater riding mower and have a fuel problem such as gas leaking from the side of the engine from a small hose approx.2inch which curves. can some one assist me.

try this get a good extension cord test it plug it in now with the trigger pulled wiggle the cord going into the weeder i have in the past moved the cord till i got working and taped it to the handle, if that dosent work get a new one

your carburetor needs to be rebuilt. It has thin diaphragms that get hard after a couple of years, sooner in hot climates. Also check your fuel lines for cracking.

1.5 CCW from lightly seated, then tune for performance not sound. The more CW the leaner, it runs best just before it ceases. Clean air filter, Fresh 50:1 (1 gal premium to 2.6 oz quality 2-cycle oil) mix, at operating temperature. HTH
Lou

Follow this link and you will be able to adjust your carberator:

http://www.zamacarb.com/tipspage.html

A couple of things may work...
Make sure you have the correct Oil / Fuel mixture, if it is incorrect the motor may have problems running.
Also take off the bottom where the cord is wound up, make sure there hasn't been any grass get wound up inside it, this will cause it to stall out on high RPM.

Same exact features, buttons and functions as this manual by Irwin.

http://www.irwin.com/uploads/documents/36_laser_tape_25.pdf

I want to use an old sensor forgiven during 30 years. I have no more manual, off course. Thanks for your answer

Most moisture meters measure the moisture content of wood or concrete is measured in percentages. So if the reading says 15 that means that there is a content of 15% moisture in the concrete.

Pressing the - (minus) button on the back toggles temperature units. Pressing + (plus) toggles barometric pressure units.

It's possible that one of the newer sensors could work in place of your 1457 sensor, but it depends on the specifications of the newer sensors and the compatibility with your base unit. The I MAX1457 sensor, which is a highly integrated analog-sensor signal processor optimized for piezoresistive sensor calibration and compensation. However, I have no information about its compatibility. If you're looking for a replacement sensor, I suggest contacting the manufacturer of your base unit to inquire about compatible sensors. Alternatively, you can check the user manual of your base unit to see if it lists compatible sensors. Garage door opener sensors are not universal. Safety sensors can only communicate with garage door openers from the same brand.