Porter Cable Popular Questions, Answers, Tips & Manuals

It could be. Check there is power going to the motor. If there is, you need a new motor, if not a wire is broken.

ck out this site.... https://nailerpros.com/porter-cable-nail-gun-leaking-air-from-exhaust-port/ And here for kit.... https://www.amazon.com/903775-Overhaul-Kit-BN125A-BN200A/dp/B0BMTS8WHX/ref=sr_1_4?keywords=bn138&qid=1688850048&sr=8-4 Best to you. Hope it's somethimg simple like loose screws.

good guess , look online for rebuild kits.

not car is a Porter Cable PCB370SS (Type 1) 16" Scroll saw

The Porter-Cable CTE 3000 generator uses SAE 10W-30 motor oil.

You may disassemble the channel where the nail exits. I have found issues where a burr causes the driver to hang. My issue was on a different type gun.

it has 2 gauges , one for tank pressure and the other is the regulator output. tank pressure is on left. The pop off is starting to release because is worn and should be replaced. if unit is only making 30 pounds on tank gauge you have other problems . If that is true personally i would replace it. https://www.ereplacementparts.com/porter-cable-c2006-type-compressor-parts-c-129_1662_16249.html

you may have to rebuild it again. inspect nail gun piston cylinder to ensure that it is not worn or scratched. Is the gun lubed before each use and periodically under heavy use?. Water from compressed air will damage gun.Use quality parts use buna n o rings not buna o rings good luck https://www.ereplacementparts.com/repair-center/article/7451/How_to_Install_an_Overhaul_Kit_in_a_Porter_Cable_Nail_Gun.html

The nose tip is most likely stuck in the ready to fire position from too much force being applied when nailing. These guns are small and sensitive to forces being applied. Try bumping it to see if the nose tip is retracting and compressing with each bump. Unplug and unload the gun before trying to pull the tip of the nose to retract if it is stuck. Check for foreign objects obstructing the trigger and safety mechanism

check ram is returning /retracting all the way --debris in feed rails --damage feed rail

Usually dependant upon load and RPM of engine.

try porter cable

Possibly water in carburetor fuel bowl. Drain and clean bowl.

https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk03CGQIst67YHdelAmbXaXM6i6L2-g%3A1607043744595&ei=oIrJX5_VI6HH_Qa7k6j4BA&q=fn250c+porter+cable+parts ..

There are several how to videos on that item posted on youtube. Also the overhaul kit comes with instructions and special tools that you may need

did u get the broken nail head out of the gun?

https://www.ereplacementparts.com/repair-center/article/7451/How_to_Install_an_Overhaul_Kit_in_a_Porter_Cable_Nail_Gun.html

You need to oil the gun. Put a drop or two on the nail driving mechanism too.

That particular battery is defective and falsely indicating it is charged.