Planar Logo

Planar Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 254 Products
  • 267 Answers
  • 62K Views

No, there is no microphone listed in the specs, just integrated speakers

Planar Computers... | Answered on Aug 03, 2015


replace/repair the touchscreen glass / controller

Planar PT1700M... | Answered on Jul 19, 2015


I use either VGA or HDMI connectors to connect to an external monitor.
I'm not sure what you're asking on the "power cord". Are you asking about the charging "brick" and such? Or?

Planar Computers... | Answered on Jun 02, 2015


You will need to go to advanced settings under resolution options and set the display to 60hz refresh rate then go back to resolution and set your native, the problem is its probably trying to default to 75hz and is causing an issue

Planar Computers... | Answered on Apr 22, 2015


Does anyone know where to find this board? My firewire connector broke off. Or can anyone soder it back on?

Best Regards
William
datq2th24d0-fuuin02dbmr03jeiykdieuip-4-0.jpg

Planar PX2230MW... | Answered on Apr 21, 2015


try the capasitos in the in line of the circuit they have to be electrolitic condencer some times with the time they open and made the monitor not work try it wiht analog multimeter is more easer know if the condencer are bad

Planar PE191M... | Answered on Mar 22, 2015


Try Another Monitor---If OK--Problem Is With Your Monitor---If Does The Same Thing--Problem With Computer Video.

Planar Computers... | Answered on Mar 18, 2015


eBay..... search for DX2, and also under Planar Dome. You'll need the software from ndssi.com, under the cx section.

Planar Dome C3i... | Answered on Feb 18, 2015


Only the Planar Dome DX2 card..... no other. Planar did this on purpose to sell those cards at 2k each. Now very reasonably priced on eBay, but they'll only work on XP, not W7.

Planar Dome C3i... | Answered on Feb 18, 2015


For your Plana Dome C3i you can get the drivers and CXtra calibration software under the cx section at ndssi.com. You must use a DX2 card (eBay) and XP. No go on W7 for those.

Planar Dome C3i... | Answered on Feb 18, 2015


Not possible.... same as with the C5i I posted on. By the way, you don't need a dual link cable to run either the C3i or the C5i with the DX2 card..... single link DVI only is fine.

Planar Dome C3i... | Answered on Feb 18, 2015


Your monitor has 3 years warranty, I would find out if you can get the replacement before opening up the case.
http://www.planaronline.com/product/?id=997-2723-00

Planar PE171... | Answered on Sep 29, 2014


The Planar PX2210MW is notorious for bad electrolytic capacitors. Specifically capacitor C804 on the power supply board. . This is a 1000uF 25volt capacitor. That capacitor was usually made by Hermei and it was purple. Normally, the top of a capacitor will be flat. When it fails, it will be curved upward and there may be some brown material leaking out.
If the monitor still will not work after replacing C804, the problem could be Q805 or Q806. These are located on the under side of the board. They are small black surface mounted chips. There are 8 pins on these chips. I have seen both AO4620 and APM4548A part numbers used. These chips contain a pair of MOSFET transistors. One transistor is n-channel and the other is p-channel. Look for a short in one of the transistors. I have repaired several of these monitors. C804 is always bad. How ever, in three cases, Q805 or Q806 was also bad 12c1ec2c-5a6d-4352-af31-150a0a92514c.jpg c9a53aae-2999-45c7-ad78-44ba51ac5a6c.jpg 795d93fe-9678-46c2-820a-767bea9babb0.jpg

Planar PX2710MW... | Answered on Aug 29, 2014


Monitors use your video drivers it should work as soon as you plug it in...
  • Is it connected properly?
  • Are you drivers up to date?
  • Are you using a video card?

Planar Px2710mw... | Answered on Aug 12, 2014


Hey if you go into system prefs > displays > arrangement you can drag the white bar on the top to the other screen you're using (status bar from the top and the dock). Not sure if that's what you're after but may help.

Planar PR5022... | Answered on Jun 26, 2014

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Planar Experts

Thomas F. Schneider

Level 3 Expert

2715 Answers

William Miller
William Miller

Level 3 Expert

9156 Answers

Steve Allison
Steve Allison

Level 3 Expert

5569 Answers

Are you a Planar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...