Fuel not getin to the carb
Check the fuel tap and filter that there is no blockage there. If not that then your needle and seat in the float chamber may be jammed closed and not letting fuel in. Check also for kinked or blocked fuel supply line.
Hi my pitbike isnt running
try a new spark plug first.if no different look at your carb dependining on what model you have you will see on the side ethier 1 or 2 screws usualy 1 as a spring the othe doesnt hold you throtal full on in neutral after warming it and with a screw diver turn the screw whithout the spring qaurter turns but count as you know ware it was first you will here the difference in the engine
4/4/2011 10:28:33 PM •
Pit Cycling
•
Answered
on Apr 04, 2011
I have a ssr 125
It sounds like you need to overhaul and clean out the carb. There may be jets and passages partly clogged and are restricting your fuel flow at wider throttle settings.
There is no spark it
there are 2 things you can do
1. check the plug/coil connection
2. make all the coil wires are hooked up properly
3. buy a new coil
3/24/2011 4:44:55 PM •
Pit Cycling
•
Answered
on Mar 24, 2011
When i pull the excellerater
you could check 1 of 3 things
1. the type of gas/ mixture
2. check the oil ( regular oil changes )
3. exhaust leak from the head
3/24/2011 2:23:09 AM •
Pit Cycling
•
Answered
on Mar 24, 2011
I unscrewed the throttle cable
In side the carby where the throttle slide sits is an idle screw, you will have to make sure that the screw sits inside the gap in the slide so have a look where the screw is slot the slide back in and turn it gently till it drops down into place
My oil is sprayig from
All bikes have a rubber seal that sits in the case and around the gear leaver, if you take the leaver off you will see it if the seal is in position eg (flush with the side if the case) then it will most likely need to be replaced, however if you are lucky you might find that it has piped out and may be able to get away with just very CAREFULLY pushing it back in so as to make sure it doesn't catch on the edge and tear cos then you would be replacing it anyway
Not finding what you are looking for?