My pit bike wont tick over
hey mate could be a few things, dirt in the jet easy fix take petrol float off the carb clean jet with w..d. Or there are two screws on the carb one petrol and one air mix the one u want his the petrol one. this will be very close to the accelerator cable and will have a spring on it turn it clockwise. VERY SMALL MOVEMENTS u will hear the engine rev faster as u turn the screw. hope this helps ****
2008 110cc pitbike wiring pictures
are you getting a spark?if not then i would suggest the kill switch has gone o/c put a meter on it on contenunity and it should buzz out when switchedJohn
When i hold the clutch in on my 125cc xsport
If it sounds like there's a ball bearing rattling around in your engine there probably is... take off the side cover and investigate it can't get any worse...if you keep riding it it'll only go bang and wreck the whole engine
Engine oil type
ther is no need as it is a 4stoke engine but if it is a new engine make sure u run it in and dnt over heat it
My pit bike wont stay runnin
sounds like your carb could be blocked with dirt if it wont start unless you put juice down plug i would take the carb off and give it a good clean and also make sure the jets ok just clean them with carb cleaner and a paper clip
Hi need to know timing settings for 110cc engine
put magneto on <T>top,take off head and place piston till flush with head,place top end back onput timming chain back on and cog with dot facing right between the two markers nw the valves r shut,happy treking
Bike wont fire. has no spark
Sounds like you have all the right new parts. I would double check the wiring. Sounds like that is where the problem is at unless the new coil is bad.
Not finding what you are looking for?