Philips Popular Questions, Answers, Tips & Manuals

There are three ways to get the code https://www.fixya.com/support/r29874205-need_vehicle_radio_code ..

Question edited for clarity. It you have standby, that shows you have power. The only things you can try is a Power Reset, disconnect from the mains, for 10 minutes. Press and hold the power button for 60 seconds and then plug back in. If you are using a remote, check the batteries in the remote. You can also do the check to make sure the remote is putting out a signal. Aim the remote at the front facing selfie of a smartphone. You should see a flash. No one else has reported your issue. https://www.google.com/search?q=Philips+fr-968+radio+receiver+no+sound+or+display ..

The system must run through its routine before it can start up. If a mechanism is jammed or a switch is not contacting, it won't complete its routine and therefore will not start up.

Remove the cover on the back of the tv. Look for swollen or leaking capacitors. They kinda look like batteries. If they are bulging or leaking then that is your problem. You will have to de-solder the old ones off. Then solder the new capacitors onto the circuit board. Capacitors will cost about 20 dollars and installing them isn't that hard to do. It will fix your tv 99% of the time. So it is worth a try!

Question edited for clarity Question moved to from Misc to a better category. If it is not turning on at all either an internal fuse has blown or it has failed electronically. Take it to an audio engineer for diagnosis. https://www.manualslib.com/manual/173431/Philips-Hts8140-93.html?page=48#manual ..

There doesn't seem to be one for this chinesium speaker.Probably a throw away item and not serviceable.

The theft deterrence option is available from the SmartControl software that runs on a Windows PC connected to the 276E monitor. See https://www.usa.philips.com/c-p/276E8VJSB_27/4k-ultra-hd-lcd-monitor/support . Scroll down to the Software & drivers section. Then unzip the file to install it. Inside the software, the theft deterrence item is under the Options section of the menu. Since a PIN is needed to enable or disable the "feature". It seems unlikely to be enabled accidentally. Did someone else use the monitor for a while? Are you using a different computer with the Philips 276E? I hope this helps. Cindy Wells

https://www.fixya.com/support/r29872378-universal_remotes_no_facsimile_remote How many would you like?

Genuine PHILIPS NA725UD DVD VCR COMBO Remote ...

eBay https://www.ebay.ca > ... > Remote Controls Genuine PHILIPS NA725UD DVD VCR COMBO Remote DVP3150V/37 ; Quantity. 4 sold. 8 available ; Item Number. 143886913897 ; Compatible Brand. For Philips ; Accurate ... $67.67 · ‎In stock

PHILIPS 996500027557 DVP3150V37, DVP3150V, ...

eBay https://www.ebay.ca > ... > Remote Controls PHILIPS 996500027557 DVP3150V37, DVP3150V, DVP3150 REMOTE CONTROL ; Model. DVP3150V ; Type. Remote Control ; Accurate description. 5.0 ; Reasonable shipping cost. US$59.95

Buy PHILIPS NA725UD -996500027557 DVD/VCR Combo ...

ReplacementRemotes.com https://www.replacementremotes.com > philips > buy-... PHILIPS NA725UD-996500027557 dvd/vcr remote control for DVP3050V, DVP3050V/37, DVP3050V/37B, DVP3050V37, DVP3050V37/VCR, DVP3050V37B, DVP3150V, DVP3150V/37

Best advice here https://www.fixya.com/support/r29872378-universal_remotes_no_facsimile_remote So many codes, good luck with that :>)

3-Digit Codes

• 856
• 734
• 837

4-Digit Codes

• 2113
• 3175
• 0816

5-Digit Codes

• 33279
• 72303
• 32113
• 23175
• 33175
• 42113
• 31957
• 43175

iLive remotes https://www.google.com/search?q=iLive+Sound+Bar+replacement+remote ..

Limited help here, but these machines need dealer service every 6 to 12 months depending on use. Of course they don't tell you this when you buy them. https://www.google.com/search?q=Philips+Lattego+water+light+stays+on ..

In order to pair your RMT-D197A remote to your Philips TV, follow these steps: 1. Power on the TV with the remote. 2. Press and hold the Setup button on the remote until the red LED light blinks twice. 3. Input the four-digit code that corresponds to your brand of TV on the remote. This should be found on the enclosed code list. 4. Release the Setup button. If the code is correct, the red LED light will blink twice. 5. Aim the remote at the TV and press the Volume Up button. If the TV responds, the remote is paired correctly.

The code you need to program your Philips TV using the Sony RMT-D197A is: 741

See page 47 Speaker section. Parameters of speakers are given. You can attach any device whose output matches same parameters as of speakers. p026-051-FWD798_37_EngB (philips.com)

Try these troubleshooting steps If they fail, contact customer support for the product. https://www.usa.philips.com/c-p/QC5580_40/norelco-headgroom-diy-cordless-hair-clipper/support

There are only three ways to get the code. https://www.fixya.com/support/r29874205-need_vehicle_radio_code ..

Just to be clear, we are FIXYA, we aren't Philips, we just have a category for handy filing. The software isn't available online, just drivers. You would have to contact Philips direct. https://www.google.com/search?q=Philips+lifeview+software ..

This sounds like a panel issue Sarah, if this is the case the set isn't repairable.

The Philips iPod dock model "AJ300D/05" is not responding when plugged in. To troubleshoot:

1. Check the power source and ensure proper connection.
2. If applicable, look for any blown fuses as a potential issue.
3. Verify the dock connector for a secure connection with the device.
4. Confirm device compatibility and consider using adapters if needed.
5. Check the remote control and its batteries.
6. Look for a reset function if available.
7. Update any associated software.
8. Inspect for physical damage.

If none of these steps resolve the issue, reach out to Philips customer support or a professional technician for further assistance or potential repair.

if new return it

I don't think you will get that to work, you have two units in one box https://www.fixya.com/support/r29872378-universal_remotes_no_facsimile_remote 'Z11' doesn't seem to be the correct alpha numerical model number. https://www.google.com/search?q=philips+z11+tv%2Fvcr+replacement+remote

Save Code list for future reference Refer to the setup ...

Philips https://www.p4c.philips.com > files > sru4000_17 PDF Save Code list for future reference Refer to the setup procedure below and look up the 3 digit code for your brand of TV, VCR, etc., from the list below. 2 pages Missing: z11 ‎' Must include: z11

Philips 4 digit remote codes for Combo devices - eliztech.com

eliztech.com https://www.eliztech.com > remotes > philips-4digit-co... Four digit code lists for HTIB and TV/VCR/DVD/DVR/SAT/CABLE Combos - Philips universal remote controls. Missing: z11 ‎' Must include: z11

Philips Universal Remote Control Programming Instructions

directutor.com https://www.directutor.com > content > philips-sru210... Program your audio and video devices with Philips Universal remote codes, simple steps for programming Philips universal remote...