Question edited for clarity and spelling of maker.
Question moved to model category.
Contact the maker for warranty repair or paid repair, or if you want to try and fix it yourself check the wiring to the controller.
They won't work with a Lithium battery. The controller circuitry doesn't understand this weird new battery. They don't work on electric kiddy bikes without changing the controller and then not all work as expected. They also don't work on full size motorcycles as a starting battery.
To adjust the throttle cable slack on a Piaggio ET2, you will need to locate the throttle cable adjuster. The adjuster is typically located near the carburetor or the throttle body.
To adjust the slack, first loosen the locknut that secures the adjuster. Then, turn the adjuster clockwise to tighten the cable or counterclockwise to loosen it until the desired slack is achieved.
Once you have adjusted the cable, tighten the locknut to secure the adjuster in place. Be sure to test the throttle to make sure it is functioning properly before riding the scooter.
If the Peg Perego Thomas The Train ride-on is not moving but the horn and whistle are still working, it's likely an issue with the motor or the gearbox. Here are a few troubleshooting steps you can try:
Check the battery: Make sure the battery is fully charged and properly connected. If the battery is old, it may need to be replaced.
Check the wiring: Inspect the wiring for any damage or loose connections. Ensure that the wiring is properly connected to the motor and gearbox.
Check the motor: The motor may be burnt out or malfunctioning. Use a multimeter to test the motor and see if it's receiving power.
Check the gearbox: The gearbox may be jammed or worn out. Inspect the gearbox for any damage or obstructions. Try lubricating the gears with some WD-40 to see if that helps.
If none of these steps resolve the issue, it may be best to contact Peg Perego customer service or take the ride-on to a certified repair shop.
not a real car moved to toys (train engine)
the gear box is stripped out.
buy new box from maker
Bachman
and we are no them.
wiki that name see there support sites listed there.
or google them,.
Should be the second gear this is the owners manual also has the wiring diagram https://www.manualslib.com/manual/796621/Peg-Perego-Gator-Od0004.html?page=7#manual
hello there.
firstly im not very good with toy cars so excuse me if i get things slightly wrong
has the car been dissasembled at all? or had the wiring changed?
also does the vehicle have a PCB or is it all indevidually wired?
i would personally dissasemble the car and remove the control circuit board (if it has one) and inspect it for corrosion or rust, next dose the board in White vinegar and leave to rest it will remove any corrosion on the components (scrub it with an old toothbrush if possible) also if it has connectors of some sort i would spray them with WD40 contact cleaner.
lastly also spray contact cleaner into the Gear switch as that might be causing the issues...Good Luck!
frankly speaking:
how come you think it is "not a problem" to do such service jobs on a Vespa LX if you are not a mechanic and don't have all the tools required?
- sure you could try it - but you need enough time to check the workshop manual and get the proper tools. (eg. sometimes the nut on the rear axle is stuck and need to be heated by a torch)
- to change the tubeless tire you will need also a tire changing machine which only tire shops or bikedealers have.
https://www.yumpu.com/en/document/view/26764401/service-station-manual-vespa-lx-125-150-4t-euro-3
