Panasonic VIERA - Popular Questions, Answers, Tips & Manuals
What board should I change
Three blinks of the power LED indicates an over-current or over-voltage condition in one of the DC supplies of the AP board. The AP board is repairable. Therefore the use of an ohmmeter and peak-hold-voltmeter is required to determine the cause of the shutdown. An over-voltage condition is definitely a defect of the AP board. An over-current condition may be due to a short circuit located in the AP board, A board, or the LCD panel.
WHEN PLUGGING TV IN, RED LIGHT BLINKS 10 TIMES BUT DOESNT COME ON
Those blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
http://homenol.blogspot.com/
http://electronicshelponline.blogspot.com/
If blinks continue without any pause, the main board is faulty.
Search the site by type in the "
brand name" to your device,
[Exclude the model number] in the "
Search box at the top right of the display window of the Homepage" to get gathered related posts.
Th42px60u
Most likely is the power board,so I hope you got a good one! The next would be a short on the SC board. The main digital board could be defective in mis diagnostic. Disconnect the SC board and see if the blink code changes. if it changes,the main board is good. If you have a good power board,I vote for a short on the SC board to be checked
Panasonic viera 42 inch plasma,
It sound like you are using a component video connection to the TV, which is of variable specification. Try a different type of video feed from your Comcast box
Light green stripe down the middle ...
This fault is most likely caused by the plasma panel itself, which would be prohibitively to replace. I suggest contacting Panasonic service and tell them about your problem. I have known Panasonic to be very good in the past, often still helping out even when the item is out of warranty.
I have a Panasonic Viera
If you are using a direct Cat5/6 cable connection between the unit and the modem, you should not have to enter any codes as this is a direct communication from one device to the other. If you were using Wi-Fi Wireless, ye; then you need codes to authenticate the connection.
DOES PANASONIC 42" VIERA TH-L42U5S" BROADCAST
No this TV does not process video files from USB. To improve sound quality reset the sound settings to midrange on all settings. Too much bass causes the sound to be muddy, especially on vocals
Not finding what you are looking for?