Ozeri Popular Questions, Answers, Tips & Manuals

If there is still power in the battery and it is inserted correctly then the connection may not be being made. Check the spring and flat connectors are tounching the battery tightly. Has your scale been wet? This could cause a short. If non of the above it is a loose wire and you should return if under guarantee or have repaired/replaced.

I'm convinced that actually all these "non-stick" pans are scam. All of them look very nice at first and then they start to stick and get black. I have the same problem with rather expensive ceramic nonstick "marvel" I bought last year. Some time ago I bought a really good nonstick pan but it is very big - 15"! After I found out that it was what I've been looking for, never could find the same type in a smaller scale.So, I presume, just should continue testing till we get the real one

On the back of the scales under the Ozeri sticker, you will find the battery cover. Remove the cover and replace the two CR2032 batteries (model ZB13).

Just the first time.

I fixed this on my scale by going through every profile and changing the height and age, setting the two main ones correctly (but swapping my wife and mine) and then setting the rest to be very short and young. Then I pressed Set, picked my profile again, and weight myself. At this point I no longer got the PIP2 error.

Epoxy glue

Should start right up. Check make sure batteries are good and properly installed. If terminals are dull looking shine them and reinstall batteries for a good connection.

There's a small "unit" button on the bottom/back of the scale. Press this until it goes back to lbs. It should cycle between kg, stones, and lbs. If that doesn't seem to be working, press and hold for 4 seconds or more. The screen will flash "reset" and it will have gone back to default, factory settings.

This pedometer is programmed to go to sleep for a couple of reasons.

1. To save battery life.
2. To not inadvertently add steps to jostles or shakes. This pedometer has been programmed to only start counting steps at your 10th step from the sleep mode. This is to help with the accracy of the device.

DOES IT HAVE ANY BATTERIES THAT MIGHT NEED TO BE REPLACED?

oUt2 means that it needs to be calibrated. I am not familiar with these scales so no sure if they can be re-calibrated.

I scanned my instruction manuel this morning and have now uploaded it to this website. If you still need one, please check this site's manual file.

http://voices.yahoo.com/know-more-than-weight-ozeri-touch-digital-7473256.html

I've uploaded a copy of my manual this morning. Please check under Ozeri 4x3Razor Pedometer.

There is an almost invisible button on the bottom of your scales. You simply press it and it will change from KG to LBS.

There is a bad connection in the board inside the unit.

1. Press and hold Time button until Hour/Min. flashes
2. Press Time again; Mon. flashes
3. Press Scan (down) or Memo (up) until the current month is displayed
4. Press Time; next field flashes
5. Press Scan (down) or Memo (up) until the current value is displayed
6. Repeat steps 4 and 5 until all fields are set to appropriate values
7. Press Time again; date and time are saved

Here is a copy of the instructions for the Ozeri 4x motion digital pedometer. I hope this is not too late. Regards. Timothy Raines