Why my womb get so painful?
You might have a bladder infection, but it could be something else. A bladder infection is easily fixed if you see a doctor and get a prescription. Be sure to drink plenty of water!
How to repair broken left front ball joint
Most are pressed in which means they need to be pressed out snap on makes a ball joint pressing tool if it has a snap ring you can knock them out with long brass punch but have to be pressed back in with that snap on tool requires a bit of skill
How do i get the rubber boot onto my balljoint without destroying it 2007 silverado 1500 classic. "master ride" ball joint
They will go on, but can be very hard sometimes since its a very tight fit. Two things you can do. Use a vise, if you have one. Use one socket to hold the bottom of the joint, and the other on top to push down the seal. Before doing that put the ball-joint in the freezer overnight, it will shrink the metal a few thousand, just enough to make it easier to get it on. Then place it in position and crank down on the vise, it should clear the lip and stay in place. A light wipe of WD40 on the lip will make it slide on easier, just use a very small amount on your finger.
How long would it take to recover after surgery
Surgical
procedures to repair Hernia these days could be completed in less than an hour
or two in cases of inguinal hernia. Just
as with any surgical procedure, the body needs time to heal after a
hernia surgery. In most cases, patients are
allowed to leave the hospital on the same day as the procedure unless there are
any unexpected complications. Recovery process is gradual. If your work does
not involve much physical exertions, you could be back at work in 10 days or
less. But make sure you do it in consultation with your doctor. Gentle
exercises are advised as part of the recovery process. But you'd have to be
patient until your body fully recovers from the surgery before you decide to
start working out or unduly exerting yourself.
Bad ball joint on ford truck
If there fork tool remover is not doing the job as the ball has fallen apart then get a threaded bar ,a nut and a piece of tube. screw the nut about 1/2 way up the bar fit the tube over the bar and place the tool between the top and bottom ball joints. screw the nut down until pressure is exerted on the ball thread you wish to remove Hit the area of the ball taper and the joint will fly out.
How to remove ball joint from a e-type jag
Use a ball joint drift. A ball joint drift is a "U" shaped wedge with a handle to hit with a hammer. Should be able to get one from Supercheap Auto, Auto-One, Repco or other similar supplier.
Not finding what you are looking for?