The batteries in the remote may be weak. replace The transmission window on the remote may be blocked, or the Infra-red diode may be inoperative. No digital signal is leaving the remote. The receiver window on the TV may be blocked, remove obstruction. Differential test. Does another remote control the tv? If you don't have one remember that the app "Peel Remote" for your smartphone may be used. Does your remote work on other electronic devices? If either is no then that is where your first problem lies.

Read full answer

9/17/2017 1:02:26 PM • Orion STV2763... • Answered on Sep 17, 2017

0answers

For a little while the

Read full answer

Be the first to answer 9/12/2017 7:36:03 PM • Orion HDLCD4212... • Posted on Sep 12, 2017 • Be the first to answer

0answers

Is the orion tv 42200 si freeview pls

Read full answer

Be the first to answer 9/8/2017 12:45:19 PM • Orion Televison... • Posted on Sep 08, 2017 • Be the first to answer

0answers

Orion TV cable jack broke off remote won't work I held both volume button's down I got the mean but I need to take it off cable for HDMI or the yellow red and white jacks

Read full answer

Be the first to answer 8/24/2017 10:07:32 PM • Orion Televison... • Posted on Aug 24, 2017 • Be the first to answer

0answers

I have an Orion tv model number SLED2468W. Where is the power on/off button? Lost the remote

Read full answer

Be the first to answer 8/24/2017 4:29:13 PM • Orion Televison... • Posted on Aug 24, 2017 • Be the first to answer

0helpful

1answer

Cannot get uverse (using coaxial) on 2002 orion tv even with tv on channel 3 or 4. Cannot find tv manual online to confirm tv settings.

the tv menu should have a scanner for the channels.

Read full answer

8/1/2017 1:43:08 AM • Orion Televison... • Answered on Aug 01, 2017

0helpful

1answer

My tv picture continuously runs like a film is running horizontally how do I stop it? Not a flat screen Orion model # TV1334A On old tv's you would be able to turn a knob to stop it Thank you

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary. Before going further; try a hard reset first. If it does not help you, replace the main digital board. There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; visit the site linked here. ..

Read full answer

7/27/2017 4:34:58 PM • Orion Televison... • Answered on Jul 27, 2017

0helpful

1answer