Omron Health & Beauty - Recent Questions, Troubleshooting & Support


I contacted Omron and the answer is:

SETTING THE POSITIONING SENSOR
Press and hold the clock button to reset the Positioning
sensor. The Positioning sensor is set "on" as default.
Press the START/STOP button to store the new
setting.

Omron BP652 7... | Answered on Oct 31, 2019


Omron error E1 means that the air is leaking from the cuff or the hose or the air hose is not plugged in correctly. First pull the hose out and insert it again. If the error persists find out about replacing the cuff.

Omron Health &... | Answered on Oct 18, 2019


Omron are based in Bracknell and if you go online, they will assist you.

Omron Health &... | Answered on Oct 04, 2019


I have one purchased at Costco in Mexico. The online company manual FOR THIS EXACT MODEL (HBF-514C) says you can choose metric or imperial. HOWEVER, that line in the manual that came with mine IS NOT IN MY MANUAL! That line and only that line was deleted from my manual, although the scale carries the exact same model number.

Omron Health &... | Answered on Sep 06, 2019


I have a hem Omron 637,but nothing happens when i press the start button

Omron Wrist... | Answered on Jul 26, 2019


No, it self calibrates.

Omron Health &... | Answered on Jul 03, 2019


Same problem on my Omron HEM-711. Manufactured in 2003, past the 5-yr warranty. Cust Suppt told me to replace unit. I opened the unit up and looked inside. Two very tight phillips screws, one on back panel, other in battery compartment. Case pries apart. LCD display looked intact, ribbon was undamaged. Unit appeared to work properly, just did not display correct reading, some of the liquid crystals in a few of the digits were not activating. I installed batteries with case still open, turned power on while pressing ribbon along edge of circuit board. Ribbon is manufactured with glue to circuit board, some of the leads come loose after several years due to manufacturing defect. In my case, pressing towards the bottom side corrected problem. You can see when it's working properly because all the display crystals light up simultaneously when unit is first powered up. I clamped down ribbon with two small paper clips insulated with a few bits of paper, works fine now, saved eighty bucks.

Omron HEM-711... | Answered on Jun 04, 2019

Not finding what you are looking for?
Omron Logo

592 questions posted

Ask a Question

Usually answered in minutes!

Top Omron Health & Beauty Experts

The Knight
The Knight

Level 3 Expert

76143 Answers

Anthony Ward
Anthony Ward

Level 2 Expert

397 Answers

jay kaye
jay kaye

Level 3 Expert

305 Answers

Are you an Omron Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...