OKI C330dn Call Service fatal Error:980
That particular error indicates a fuser failure. Try turning off the printer and re-seating the fuser. If this does not clear the message then the fuser needs to be replaced. With such a low number of prints warranty should cover it.
What does this mean 010: Fatal Error
010 is not listed in the technical manual for this printer. But 002, 007, 009 and 011 are listed and pertain to the RAM DIMM. For those errors it is suggested to remove the RAM DIMM and restart the printer. If it recovers then replace the RAM DIMM. If it fails again replace the CU pcb.
381 error paper jam oki b431d
381 error indicates a jam under the drum. If no jam exists try using canned air to blow out the printer. Caution, toner dust may blow up in your face.
133
That error is an LED detection error. Check the connections for the cyan LED. Also the fuse on the pcb for that LED. If those check out OK than you can try swapping the LED's to see if the error travels with the LED. If the error travels then replace the LED. If the error does not travel then it is more likely the PCB.
173:fatal error
The fuser thermistor has detected an abnormal temperature. Cycle the power. If the problem persists then replace the fuser. If the problem still persists then replace the low voltage power supply. The fuser part number is 44289101 and is available at www.l-lsystems.com
928 fatal error
Thons is an issue with your computer (Windows right?)Try To do a registry cleaning with a free registry cleaner.
Oki b431d paper jam
Paper jam is initiated by a sensor that does not register (or tell the logic board it has registered) a movement of the paper through the printer. Try finding out what sensor is near the point the paper stopped. Look if anything id blocking a optical sensor, or any small lever is blocked in free movement. Close all covers correct and make sure nothing is blocking the covers. Not even just a small piece of paper.
Not finding what you are looking for?