Nyko Recent Questions, Troubleshooting Help & Support

I have purchased this wand in the past and I found it to be very troublesome and prone to many issues.
The Nyko wands also had some that were not compatible with the Wii Motion Plus.
As for connecting your wand, what worked for me in the past is hold down the Sync button on the Wii and then hit the sync button on your wand. This is located usually under the battery cover.
This should connect the wand for you.

It should take 3-4 hours for your battery packs to charge. I hope this helps!

ok you will need to synchronization.Press the power button on the wii conosle to turn it on remove the battery cover on the backof the remote.Press and release the SYNC. button inside the cover.the player leds will blink.Open the fornt door on the wii console press and release the SYNC.button on the inside of the compartment. when the player LED blinking stop connection is complete the LED that is iluminated indicates the player number, THAT IS IT

Try contacting Nyko company to see if they have any solution. www.nyko.com I have the same charge station and discontinued using it because it would not charge my controllers after only a few months of use. I’m happy to assist further over the phone at https://www.6ya.com/expert/jonathon_2815d94e62f0ea08

Hi,
First thing to , replace your remote battery with new one.
Regards

reset controller pin hole on back then press raven button while light is blinking

reset contoller pin hole on back then press raven buttom while light is blinking

reset controller then press raven button while light is flashing

reset the controller then press the raven button on front as light is blinking

1. You need 3 other controllers besides the Nyko guitar (they can be the rockband instrument set, or just any PS3 controllers. I used a DS3 a RB guitar and GH3 guitar)
2. You need all 3 of the controllers assigned to the PS3 taking up spot 1-3 except the Nyko guitar (goal is to assign the Nyko to 4 or higher)
3. Plug in the Nyko dongle and attempt to link with the guitar (it will most likely make the Nyko button turn red which is the color that won't play)
4. Turn the switch on the dongle back and forth once or twice ending on GH setting letting the guitar link on it's own (It may not assign correctly on the first try, but keep switching between Rockband setting and GH setting. Always end on GH, because it will work with Rockband on GH setting)
5. After a few times it should link and allow you to play

Problem is the firmware of the PS3 (V3.10 or higher)

Hi there,

The Nyko Air Controller is meant for PC Games, so if you're using it on the 360 or the PS3 you might run into some problems. I've used this controller myself so I can speak from experience. What you want to do is download the calibration software from Nyko's website:
http://www.nyko.com/customer-support/
If you're using this to play an Emulator you will need to set up the Joystick Calibration in the settings. (Almost any game for that matter you are going to need to use the in-game settings to calibrate the joystick.)
Hope this helps.

On the Wii menu, if you press home button, and click "Wii Remote Settings" then "Reconnect" it will enable you to connect wiimotes by pressing 1 and 2 simultaneously. Also some games, Wii sports for example, allow you to use one controller for two or more people.

Hi,
What I think you need to do is use the USB cable for charging the controller, this will sync your controller with your PS3
Hope that helps, Dan

how to put a nyko wii to the 2nd control

Hello, I am having the same exact problem and noticed nobody answered your question. Have you figured anything out yet?

You have to turn them off.