Nu Mark Answered Questions & Fixed Issues

Some laser assemblies will have trouble reading discs from a computer. TOC errors usually.

for sure keeping electronics outside exposes them to temperature changes , which causes condensation on any available surface during the night when its cold , get those babys inside where theres a consistant temperature , next question , how does one draw liquid trapped inside circuitry back out again ??////

my outputs dont have signal

JUST TRY :)

hello...
try to change the .avi format to DivX format by using a software :

Ashampoo movie shrink and burn
http://download.cnet.com/Ashampoo-Movie-Shrink-Burn/3000-2194_4-10253972.html

thats the best software to convert :)

(0r)

try this one
ConvertXtoDVD3


http://www.youtube.com/watch?v=Ij_O8scGU94


download

"http://www.vso-software.fr/products/convert_x_to_dvd/"

nJOY HF

You might have a centering control among the options of your monitor. Look up the manual, or just play with the buttons until you find it.

Hi,You may have dirty lens. You can clean it using CD lens cleaner or clean it manually.If no joy, your optical lens may defective and need replacement. Other possiblity cause is the mechanism is out of service.Regards

Check your cable again. Cables for patch panels are DIFFERENT. The tip on a patch cable is smaller in diameter and has a point on it. A 1/4 inch TRS cable's tip is larger and has a rounded tip. If you're sure of your cables, then replacing the jack in the mixer isn't so bad if you're handy with a soldering iron.

power supply problem

This moel is not a karaoke player

I'm afraid more details are needed.

I solved this exact problem by re-calibrating the units follow this link to see how :) http://www.numark.com/images/product_downloads/axis9_recalibration.pdf

follow link for numark axis 9 calibration :) http://www.numark.com/images/product_downloads/axis9_recalibration.pdf

follow this link for axis 9 cdj calibration http://www.numark.com/images/product_downloads/axis9_recalibration.pdf

I don't know how you are using the mixer are you using it as an interface? or are you directly running speakers to it? start with checking speaker cords I had an issue once that I accidently grabbed a mic cord and used it every system is different but on mine it cut input to all my speakers till right cord was replaced with good one if that's not it give me alittle more info on how your using it before I can touch on it further good luck

went trun my numark dvd 01 on they is on light on the display

Yes, you just need the appropriate cables. The simplest being a 3.5mm jack to phono to make a direct link tween your laptop output and one of the two channel inputs. Then you simply choose phones on your front end (whichever channel you plugged into) and away you go.

The unit needs service- take to a service center or consult a Technician to see what can be done about the unit. Could be internal switches dirty.

my numark cdn90 door opening and closing cd not reading

all light on solution... replug the 2 cables for integrated circuit on the picture.

i solved the all lights on problem by replugging 2 cables into the cdx. it's the 2 integrated 3 pin circuit for cdx power, they are not soldred but just plugged in. look the picture for detailles.