Nu Mark Popular Questions, Answers, Tips & Manuals

for sure keeping electronics outside exposes them to temperature changes , which causes condensation on any available surface during the night when its cold , get those babys inside where theres a consistant temperature , next question , how does one draw liquid trapped inside circuitry back out again ??////

You might have a centering control among the options of your monitor. Look up the manual, or just play with the buttons until you find it.

Some laser assemblies will have trouble reading discs from a computer. TOC errors usually.

Check your cable again. Cables for patch panels are DIFFERENT. The tip on a patch cable is smaller in diameter and has a point on it. A 1/4 inch TRS cable's tip is larger and has a rounded tip. If you're sure of your cables, then replacing the jack in the mixer isn't so bad if you're handy with a soldering iron.

power supply problem

follow link for numark axis 9 calibration :) http://www.numark.com/images/product_downloads/axis9_recalibration.pdf

follow this link for axis 9 cdj calibration http://www.numark.com/images/product_downloads/axis9_recalibration.pdf

I solved this exact problem by re-calibrating the units follow this link to see how :) http://www.numark.com/images/product_downloads/axis9_recalibration.pdf

This moel is not a karaoke player

I don't know how you are using the mixer are you using it as an interface? or are you directly running speakers to it? start with checking speaker cords I had an issue once that I accidently grabbed a mic cord and used it every system is different but on mine it cut input to all my speakers till right cord was replaced with good one if that's not it give me alittle more info on how your using it before I can touch on it further good luck

I'm afraid more details are needed.

Yes, you just need the appropriate cables. The simplest being a 3.5mm jack to phono to make a direct link tween your laptop output and one of the two channel inputs. Then you simply choose phones on your front end (whichever channel you plugged into) and away you go.

The unit needs service- take to a service center or consult a Technician to see what can be done about the unit. Could be internal switches dirty.

Output IC might be damaged. Seek tech support.

The laser pickup is shot, the whole assembly will need to be replaced in order to get it up and running properly.

Visit this site for more details. Type in the site name "Electro-help" either Google or Yahoo search box [not in the address bar of your browser], and click search. It is an electronic equipments service help site. All details you want are there. Note the position of hyphen in between words in site name, when you type it in. The site will appear as it is in web; subtitled as service help to electronic home entertainement equipments.

Pull up older posts. You can gather all details. Sometimes, click open the adverts' by the side and bottom of each post might give you more details.

Hi,You may have dirty lens. You can clean it using CD lens cleaner or clean it manually.If no joy, your optical lens may defective and need replacement. Other possiblity cause is the mechanism is out of service.Regards

my numark cdn90 door opening and closing cd not reading

Get a laser lens cleaner - the kind with optical quality brushes built in to the disk. If that doesn't do it, it's a more serious hardware issue and will require service or replacement.

whe can say that it can take a minute to a financial problem with the olympus digital cameras