NRS Exercise & Fitness - Recent Questions, Troubleshooting & Support
Error code 1
I am the same Problem with Stex 8020 T Error Code 1
Belt is slipping, even on the lowest power.
To tighten the belt, start by
locating the two bolts that adjust the
rear roller (one on each side of the unit in the back). Run the unit at
about 3 mph. Tighten the bolts a 1/4 turn at a time. Make sure that
what you do to one side, you MUST do to the other side or the belt will
get off center. After you tighten it 1/4 turn, check the belt to see if
it is still slipping. If it is then tighten the belt 1/4 turn again.
Continue until the belt does not slip, but do not tighten the bolts more
than 2 full turns.
As far as the manual, I have not been able to found it anywhere yet.
Not finding what you are looking for?