Nostalgia Electrics Kitchen Appliances - Others - Page 3 - Recent Questions, Troubleshooting & Support

I have a Popcorn machine from Nostalgia too that had this problem. I cleaned it out and everything but it still had the problem of the it getting stuck. After days of analizing, I found the solution. after a while the ceiling of the popcorn machine starts to fall in, lowering the handles of where the kettle goes. making the knob that turns being lower that the one that makes it turn, causing it to get stuck, all I did is add so leverage so the kettle is once again at the same level or higher. Making it turn with greater force and not getting stuck. In other words make sure the turning mechanism is leveled and not one lower than the other. preferably the kettle part being higher.

Here is the direct download link for the CCP-509 instruction manual (PDF file):
http://www.nostalgiaelectrics.com/manuals/CCP-509.pdf

It is just a small spot light. Take the old bulb to your local hardware store. They will have a replacement.

http://nostalgiaelectrics.com/user-manuals/ The manual is in the Bakery section.

http://nostalgiaelectrics.com/user-manuals/ This would be your best chance.

Fixya does not sell equipment.

Double check the kettle is plugged in tight, otherwise there are no repairable parts on Nostalgia poppers.

There are no replacement parts available for Nostalgia Equipment.

i lent mine out and it came back without a cord , found one on a old burnt out pitzelle iron that worked in my pile , it's just not as long as the original lesson: look at your other appliances you might allready have one !!

repeat

No, Nostalgia poppers are not repairable, or upgradeable.

Then you are stuck with it, either that or you search for a replacement receptacle online & then take it back

The thermostat built into the kettle stops the kettle from heating at a prescribed temperature. usually around 425 F. This is hot enough to smoke and cause instant burns, but is the required temp for popping popcorn. I do not know of a "thermal fuse" built into popcorn machines. Mechanical thermo stats are not flawless. they can and do malfunction, either too cold or too hot. the model popper you have is not adjustable, or repairable. If you are tripping a electrical circuit breaker that is a different problem not related to kettle heat. It is a symptom of an overloading problem of your outlet, or a ground fault in the popcorn popper.

What would you like to know.

Hi David... Customer Service Nostalgia Electrics 920-347-9122 nostalgiaelectrics.com Regards, Dennis