Northstar Boating - Page 3 - Recent Questions, Troubleshooting & Support

I had the same problem with my 657 I found it was moisture inside the unit that was causing the low voltage alarm to go off pull it apart and let it dry out inside

Try a factory reset - that worked for me when my Northstar Explorer 660 stopped by itself again and again. You find this reset commando by pressing MENU twice and then under Systems menu, if I remember it correctly. There is also a RAM Clear commando. This is done by holding the MENU button pressed when the GPS is switched off. Keep it pressed while switchin on the GPS, still holding the button pressed until the RAM Clear menu appears. You will probably loose all waypoints etc. by doing this so try Factory Reset as your first alternative. Good Luck! // Jonas, Sweden

• I am providing a link to the installation manual. The pages you will want to reference are pages 64, 65, 66 and 67 which thoroughly cover installation with the diagrams you requested and instructions as well. I have uploaded some screen shots of the diagrams of the manual in regards to your request. The manual will have better defined diagrams on the pages I have indicated. http://www.northstarnav.com/upload/Northstar/Documents/EXPLORER_660.pdf

• Hope this helps and thank you for using FixYa.

Regards, Tony

Hi marwick3,

I saw your post about t your Northstar Explorer 457 that you are having issues with the Language on it is that correct?

If is may ask, was the language changed or did you get your Northstart Explorer in a different Language?

On you Northstar Explorer press the MENU button twice then select SYSTEM, you should see Languageo n the List from there-on you can select the Language that you want your Northstart to be using.

If it is set to a different Language then press MENU twice once you see the list the first on top is Language to the right is the language selected from there you can press ENTER to select the Language option then the arrow keys to select which language to choose once you are set to choose the language you wish then press ENTER once again to select the option.

this should help you get your Northstar back to the Language you want.

For further details regarding your Northstar you can go to the link posted below for further details.

http://www.northstarnav.com/upload/Northstar/Documents/EXPLORER_457_467.pdf

I hope that this helps.

Thank you for choosing Fixya,

mvincentc