New Bright Logo

New Bright Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 51 Products
  • 230 Answers
  • 47K Views

The sensor is a resistive load sensor. The resistance changes as the motor gets hot. Solder the wires back onto the board and whilst keeping the model off of the ground, put it into drive mode. If it doesn't go, then wet your finger and bridge the two solder points on the sensor. Don't worry, you will not get any electric shock as the voltage and current are too low.

If it still doesn't drive, then wiggle the motor wiring at the motor. If still nothing, then press lightly on that sensor pcb. There may be a broken track on it. If it is broken, then you cannot solder it. You then need to go to Maplins (if in the UK) and buy a small bottle of pure silver paint. Where the solder points meet the circuit resistive track (it'll be black carbon looking), paint one blob of silver conductive paint onto each of the track beginnings. Let those dry (five minutes) and then try it. It should work. The silver paint will only work if the wet finger trick on the black carbon track works. If no carbon track, then it may be a thermal resistor (thermistor). Replace it. Maplin sells them too, so just buy a few different types (very cheap) and temporarily solder one in place until it works.

New Bright... | Answered on Nov 13, 2013


gear box is nakerd

New Bright 115... | Answered on Oct 23, 2013


I ned battery charger 19.2 V for m'y Hommer 3

New Bright Toys | Answered on Aug 26, 2013


You can call the company from where it is made or look on their website on how to purchase replacement parts

New Bright... | Answered on Aug 13, 2013


WOO HOO I FIGURED IT OUT!!!! You have to pull it apart from the base up. First thing I did was take off the feet. If you look down the tower potion you can see a screw. Then u took off the tower. I figured out that if you just lined up the black square portion it would have come apart with just the one screw. Anyways now there is 2 more screws to get. 3 total to take the new bright tc36 tower crane apart. They are hard to see, but once the base is off you can get at em. Good luck everyone.

Garden | Answered on Aug 05, 2013


Get new battery, I have 4 batteries, all will turn it on, get horn lights, sound. 2 do the exact same thing yours is doing, 1 runs about 5 min then starts into your problem, 1 is good and will run for about 20 mins.

New Bright Ford... | Answered on Apr 03, 2013


its 1 line short in the unit that has to be checkede and made clear.this will solve check the voltages in both lines.

New Bright... | Answered on Dec 29, 2012

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top New Bright Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4387 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a New Bright Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...