How do i reset my netgear wgr614v10 router to
Hi there!
Take a paper clip, and insert it into the
little reset hole in the back of the router... hold for at least 20 seconds.
username and password: the defaults are admin and password..
Hope this helps
levibit
How to set netgear router WNDS3400 to factory settings
If you would like to reset the router to default settings then please perform the below steps:With the help of a paper clip, press the reset button on the back of the router for 20 seconds (please refer to the label on the bottom of the router for reset button location). Release the reset button after 20 seconds and turn off the router. Turn the router on after few seconds.Please reconfigure the router using its default credentials mentioned on the bottom panel of the unit.RegardsAnand
How to go from 4g to 3g
You don't need to do anything to your Wifi just insert the SIM and try to brows over the data
12/20/2018 2:05:28 PM •
NetGear...
•
Answered
on Dec 20, 2018
How To Configure FM114P or FR114P for an Internet Connection and Printer Sharing
There are three steps:
1. Configuring the router for Internet access
2. Installing and configuring the print server
3. Adding the printer to the Windows configuration
To Configure the Router for Internet Access
1. Connect the modem to the router's Internet port and your LAN computers to the router's LAN ports.
2. Shut down your LAN computers. (Power them off.)
3. Power off the router.
4. Power off the modem.
5. Power on the modem.
6. Power on the router.
7. Start the LAN computers.
8. Enter 192.168.0.1 in a Web browser's address.
9. Type username and password (by default admin and password).
10. Click Setup Wizard to configure the router's Internet access.
To Install and Configure the Print Server
1. Install the Printer Server Driver program on a computer.
2. After installation, make sure to select the Run Print Port Setup now box.
3. Click Finish. Print Port Setup runs, showing you the firewall and the printer.
4. Click Port 1.
5. Click Add. A pop-up message says whether a port was created, then the Add Printer wizard starts.
To Add a Printer With the Windows Add Printer Wizard
1. Continuing from the last section (or clicking Start > Settings > Printers > Add Printer), click Next.
2. Select Network Printer, and click Next.
3. Click Next again (leaving the port as LPT1).
4. Select the manufacturer and printer model of your printer. (If your printer does not appear, you need to get the CD or floppy that came with the printer, and use Have Disk to specify the file location. Note that it is looking for a file that ends with .inf.)
5. Click Next.
6. Change the printer name to something users on your LAN will recognize easily.
7. If prompted by the Add Printer Wizard about sharing: DO NOT enable sharing!
Now test the printer.
Other information about Windows configuration is available in Windows help in the article "To connect to a printer on a network".
Cannot connect to Internet.
The orange blinking light indicates that it cannot obtain the DNS server from your ISP (internet service provider). You must contact your ISP and check whether your service is active.
Router is blinking orange
There should be a reset button on the back on the router. Press and hold down on it, for about minute or so.
Not finding what you are looking for?
