Nespresso Coffee Makers & Espresso Machines - Page 4 - Recent Questions, Troubleshooting & Support

must first look for any leaking which m have dripped on any electrical parts after this you will need to check safety on mains plug and internal

have to look for the safety fuse first these are based on the boiler x2 then check PCB for any burn components

hi you should be able to relocate 2 thermal safety on the boiler check these two with continuity meter start here first if all is well get back to me

The power button decided to fail while it was sitting idle.

here , double insulated machine only have an active and a neutral pin in the power cable you can test by testing for continuity between the active and the metal and neutral and the metal if it has a 3 pin plug consider as not double insulated

Unplug the machine. Hold the On/Off button when plugging back.

if you dont have an internal trasformer then you may be able to find fuse or even thermal safety which are keeping you from using it .its important that thermal safety are replaced an seen or as you find 167c tempture and voltage tolerance i toy get any problem put the internal phone sow we can see internal parts used

It's normal that some of the water or and coffee flows drops into the capsule container. Mostly it will occur when you do not insert a capsule into the machine, and the rewing unit is not sealed with the capsule. The capsule container can hold up to 5 or 6 used capsule.

Similar to the crema on quality espresso, this "foam" is an indicator of the freshness of your coffee. If it's thick and creamy white, it's very fresh. If it's present but thin and watery, it's less fresh. https://www.quora.com/What-is-the-foam-on-coffee-made-of-that-appears-on-milk-based-and-even-black-coffees The foam found at the top of your cup is "crema" comes from the espresso making process. Espresso is prepared in a metal contraption, which you pound down and hot water is pumped through at great pressures. The pressure pushes out the little oils from the coffee beans into the liquid. https://www.joyridecoffeedistributors.com/blog/coffee-news/where-does-the-foam-come-from

Have you tried applying a little pressure to the lever to open it?

This problem is most likely being caused by air being trapped in the system. To fix this, please follow the following steps: -

- Turn on the Machine, ensuring there is water in the tank
- Wait until the light stops flashing and the machine is ready for use
- Lift the silver lever on top of the machine into the upright position
- Press the coffee button on your machine
- Push the silver lever back, away from you, and hold it in this position for 3 seconds
- Press the coffee button again to stop the water flow

This procedure releases the air blockage in the system and your machine should function normally again.
(from Nespresso Club)

Please read this https://www.thedebuguy.com/blog/debugging-nespresso-machine

There are two nozzles in front of the machine attached together, the nose of the bigger one on the top slides into the smaller one on the bottom. When it makes coffee, the spout outside the machine becomes lower so coffee can come out. When it is done making coffee, the spout goes up so water/coffee drips in the drip tray. If one of the nozzles breaks, the spout on the smaller one will not go down and the inside end is lower and coffee goes inside the drip tray. It has nothing to do with cleaning.

Tish3030 response worked PERFECTLY. Thank you, Tish.

Means you are not heating your milk, the frothing milk will be cold (for iced drinks) because you have held the button down longer than normal. Usually it takes 5 Seconds for the blue light to go on. try turning it on or pushing the button faster, It should turn on red, for heated and frothed milk.

Use the bar-style spinner and run it twice.

I would pierce it Myself. It's worth a shot!

Hi AJ. try this link. https://www.nespresso.com/uk/en/machine-assistance#! or this one. https://www.google.com/search?q=Nespresso+D60+won%27t+pump+water+through+the+system&rlz=1C1AVFC_enGB797GB798&oq=Nespresso+D60+won%27t+pump+water+through+the+system&aqs=chrome..69i57.3663j0j9&sourceid=chrome&ie=UTF-8

DO YOU HAVE LIGHT OF SOME KIND IS THERE ANY POWER INDICATOR ?

I DON'T KNOW. CONSIDER SPRAY OR SOAK IN VINEGAR.