MTX Car Audio & Video - Page 5 - Recent Questions, Troubleshooting & Support
My mtx JH300 amp is going in to protection mode what should i do?
have you checked the amp fuse ? also never connect while battery is connected. be sure to connect the amp to amp specs as stated in user manual i had the same problem and it was as simple as a missed connection however it could be a multitude of isues causeing the problem most of which are in the user manual. also check the earthing cable is hooked up and be sure no power supply is earthing out on the car. Protection mode is generaly activated when the amp isnt connected properly or by fault of power supply. double check evenrything and check again.
Tc 8001 red light
on some amps there is a duel light. red and green usually. red means it is in protect mode or you didn't hook up your remote wire. if in protect mode, it could mean a number of things. did you hook it up with speakers and everything?
THE AMP TURNS ON BUT
Disconnect all speaker connections and rca cables. Leave power, ground and remote wires intact. Try turning on again. If you still have a protection light your amp is faulty. Hopefully you have warranty . Please use volt meter to test correct voltage and ohm feas ng on speakers.
.A thumbs up would be greatly appreciated if this answer is helpful to you.
Fast blinking red light
Disconnect all speaker connections and rca cables. Leave power, ground and remote wires intact. Try turning on again. If you still have a protection light your amp is faulty. Hopefully you have warranty. Good L
.A thumbs up would be greatly appreciated if this answer is helpful to you.
MTX Audio
Ford code
this is the same model that i was asked about earlier. i cant do anything about this though. only ford can help you with this. thanks for asking though.
8/16/2014 4:41:34 AM •
MTX Ford...
•
Answered
on Aug 16, 2014
How to wire MTX 202 amp
this link has install sheets just match the model number of you amp to the list of mtx amplifiers to find appropriate wiring diagram
http://www.mitekasia.com/support/Default.aspx?sid=257&aid=2
81000d missing resistor
you need the resisitor, it keeps the machine from basically frying up in case of a power surge.,
Ayuda con el MTX THUNDER 895
Ojala que no pagastes mucho por el. SI tienes un tecknico cerquitas te lo puede reparad barato. Si lo tienes que mandar a MTX no conveine.
Not finding what you are looking for?