Moyer Diebel Dishwashers - Recent Questions, Troubleshooting & Support

The spring probably broke in the latch, or the door balance springs are slack. You have to pull it out and removed the side panels. The latch literally just holds it in place. You should be able to tell if the springs are holding the weight of the door though. Then split the door to inspect the latch.

The thermostat for the final rinse booster might be set too high causing the water to boil in booster tank. Water will then spray even when cycle is complete. Turn the thermostat down to 180f or 82c to comply with health regulation. If problem continues replace booster tank thermostat. Or if you have hard water pull thermostat and clean

The squeeze tube in the detergent pump probably needs replacement. It's awear item

faulty control board.

yes I would say it is the plumbing underneath the drain pan. Probably the u shaped bend in the plumbing is full of straws or bottle caps, and/or glass. Double check the hole under the drain pan screen to make sure it is clear of debris.