My Morphy Richards steam generator iron is intermittent with steam.
If your Morphy Richards steam generator iron is experiencing intermittent steam and you suspect a blockage in the hose, here are some steps you can take to address the issue:
- Check the water tank: Ensure that the water tank is filled with clean water and that the water level is adequate. Low water levels can affect steam production. If necessary, refill the water tank.
- Examine the steam settings: Verify that you have selected the appropriate steam settings on your iron. Some models have different steam intensity levels, so make sure you have set it to the desired level.
- Check for blockages in the hose: Disconnect the hose from the iron and inspect it for any visible blockages. Use a long, flexible brush or pipe cleaner to gently clean the inside of the hose and remove any debris or mineral deposits that may be causing the blockage. Ensure that the hose is securely reattached to the iron after cleaning.
- Clean the steam vents: Over time, steam vents on the iron's soleplate can become clogged with mineral deposits or fabric fibers. Use a cotton swab or a soft brush to clean the steam vents, removing any buildup that may be obstructing the steam flow.
- Perform a thorough descaling: While you have already used white vinegar for descaling, it's possible that there are still mineral deposits causing the blockage. Consider using a commercial descaling solution specifically designed for steam irons. Follow the instructions provided by the manufacturer of the descaling solution to effectively remove any scale or deposits that may be affecting steam production.
- Contact customer support: If you have tried the above steps and the issue persists, it may be best to contact Morphy Richards customer support for further assistance. They can provide specific troubleshooting steps or advise on potential repairs or service options.
Remember to always follow the manufacturer's instructions and safety guidelines when cleaning and maintaining your steam generator iron. If you are unsure or uncomfortable with any aspect of the troubleshooting process, it's recommended to seek professional assistance to avoid potential damage or injury.
I have a morphy Richards 732007 super vac and the hand held device keeps beeping and flashes green lights when start button is pressed
The beeping and flashing green lights on your Morphy Richards 732007 Super Vac handheld device could indicate a specific error or issue with the device. Here are a few troubleshooting steps you can try:
- Check the battery: Ensure that the handheld device is fully charged. If the battery is low, it might cause the beeping and flashing lights. Charge the device according to the manufacturer's instructions and try again.
- Clean the filters: Clogged filters can impact the device's performance. Remove and clean the filters according to the user manual's instructions. Make sure they are completely dry before reattaching them.
- Check for blockages: Inspect the nozzle and suction pathways for any blockages or obstructions. Clear away any debris that might be interfering with the device's operation.
- Reset the device: Sometimes, a simple reset can resolve minor issues. Turn off the device, remove the battery (if removable), wait for a few minutes, then reinsert the battery and turn it back on.
Kettle keeps turning off before it is boiled
Sounds like the thermostat has gone out of calibration. If you're handy with appliance repair it might be possible to purchase (internet) and replace that part - they're usually not adjustable. Otherwise it's a new kettle.
Not finding what you are looking for?
