Minn Kota Boating - Popular Questions, Answers, Tips & Manuals
I have a Minn Kota 315D 3 bank charger. When I plug it in to my electrical outlet only bank 1 shows a solid yellow light. I am not getting power to bank 2 and 3.
A solid yellow light on Bank 1 of your Minn Kota 315D 3 bank charger indicates that the charger is in "float" mode, which means it is maintaining the battery's charge at a safe level. It sounds like there may be an issue with the connections or wiring for Banks 2 and 3, preventing them from receiving power.
Here are a few things you can try:
- Check the connections between the charger and the batteries for Banks 2 and 3 to ensure they are tight and secure.
- Ensure that the circuit breaker for the charger is not tripped.
- Check the wiring for Banks 2 and 3 for any visible damage or corrosion.
- Ensure that the batteries for Banks 2 and 3 are not in a low state of charge or are not faulty.
- Try to reset the charger by unplugging it from the power source and plug it back in after a few minutes.
8/19/2022 11:49:02 AM •
Minn Kota...
•
136 views • 0 helpful votes
My trolling motor- 2007 70# Minnkota Powerdrive V2 seems to lose track of where it's at. I replaced both control boards and it still wanders off.
If you have already replaced the control boards and the trolling motor still seems to lose track of its location, there are a few other things you can check:
- The propeller may be damaged or bent, causing it to steer off course. Inspect the propeller for any visible damage and replace it if necessary.
- The motor's GPS sensor may not be functioning properly. Check to make sure the sensor is clean and free of debris. You can also try recalibrating the sensor according to the manufacturer's instructions.
- The wiring connections may be loose or corroded, causing intermittent power to the motor. Check all wiring connections for tightness and signs of corrosion, and clean or replace as necessary.
- The foot pedal or remote control may be malfunctioning, causing the motor to steer off course. Check the foot pedal or remote control for any damage or loose connections, and replace or repair as necessary.
If none of these steps resolve the issue, you may need to take your trolling motor to a professional repair shop for further diagnosis and repair.
Why is minn Kota I pilot power cutting off- batteries are charged
Do you have a remote-less unit Or a remote unit. Being a I Pilot I would think you do have a remote, if you left it in the box the unit is always looking for a signal that controls the computer connection.
Take the remote and remove from I-Pilot so that the system goes into manufacturing manual
7/21/2019 4:16:47 PM •
Minn Kota...
•
435 views • 0 helpful votes
Not finding what you are looking for?