Mercury Health & Beauty - Recent Questions, Troubleshooting & Support

Page 9 zoomed in to 250% shows it might have adjustment. If you feel you are not likely to tip backwards, you could even remove them. https://s3-eu-west-1.amazonaws.com/ns.drive.prod/rich/rich_files/rich_files/000/000/121/original/neo-20range-20user-20manual.pdf ..

First, make certain that you are using the recommended type of grease. Using a grease gun, slowly pump grease into the fitting until it begins to ooze out somewhere. Wipe off the (hopefully small amount of) grease that has oozed out, and you're done.

hi Dorothy, that fault is related to the wigwag not either dead center or a wiring fault related to that, the controller checks that wigwag lever (throttle lever) is not being pressed otherwise it will shoot forward or backwards, does the wigwag lever appear loose ? the lever can become loose so the centre stem moves off center, that has a slot if you look under rhe throttle, it should be dead center when you sit on the scooter. regards www.gewizrepairs.co.uk

please make sure brake is in drive mode I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

The fuse value is printed on the fuse or in the user manual that came with the scooter.

hi, if memory serves me right it located under your feet .. gently push it in...if you felt like you were pushing something back in , then it has popped otherwise no,.,.. Regards Rob

The center hub cover comes off with a small flat blade screw driver. It just pops off. Then take a wrench to remove the nut. Make sure you block up the frame so the wheel is not on the ground.

Sounds like you reversed the leads from the motor

Give batteries a break. Even brand new batteries only can perform after about 3 charge cycles. When they don't improve after 3 cycles, go back to the place you bought these and ask for others.

try 1-888-237-3297

you can check to see if it is in free wheel at the rear of the scooter there shoulb be a lever make sure it is in the lock mode

I am using Lloyds Pharmacy UK BP Monitor KD-525 MODEL. Its LCD display is not clear. I cannot recognise the numbers properly. Kindly give me solution how to repair my BP unit in India. sridhar

best bet look on ebay, or an electronics shop. if you can remove it the info should be printed on it.

There is no piston or plunger, as you would no it. It's the air pressure, when the bulb is squeezed that raises the mercury. When the valve on the bulb is released, it it releases the air pressure and the mercury falls.

What's really amazing is that you still have one of these old blood pressure monitors. They were outlawed in most countries 10 years ago, due to the high concentration of mercury in the tube. If for some reason the glass tube, that holds the mercury was broken or it leaked, you don't want to be standing around it. It's the same reason mercury filled thermometers are no longer manufactured or sold.

God day! I have checked with 4 major brands and the merc level is not adjustable. One company, Omron, told me that it is for safety and they did not want the merc played with..... Hope this helps, if so, please remember to vote.... Take care... Guy :)

Hello There, Is it a leak in Mercury, you need to get a new one. If it is a leak in air being pumped, get the tubings change. If you suspect air leakage, you can use air bubbles in water to diagnose this.
Thanks & Cheers