Maytag Kitchen Ranges - Page 5 - Recent Questions, Troubleshooting & Support

That is the way it works. If you have an convection oven then they both work in bake mode but they alternate between the two.

This is a not an uncommon issue. Replacing the control board. It solved the light & clicking issue. Check online for parts try ereplacement or http://www.appliancepartspros.com/

Sounds like the control panel is bad. Not hard to replace if you are at all handy, but it's a pricey part.

Check your thermal regulator located on the back, it is most likel a 2 screw part replacement. Thats What it was on ours, very quick and easy fix.

turn off breaker or unplug. then wires commonly burn out near the heating element. To determine if a wire has burned out, inspect the wires leading to the element. If a wire is burned out, it will often be visibly burnt.

sounds like membrane cancel button not working you need service to change membrane

It is not 5a6... it is Sab... (Sabbath mode) Hello Susan Krim, If you do not have your MODEL NUMBER (nothing came through with your question)... Find your original OWNERS MANUAL... and look up how to DEACTIVATE the SABBATH feature... ELSE... Get the model number and go to my favorite FREE manual site... ManualsLib Makes it easy to find manuals online Hope this helps... Next week too... Carnac the Magnificent

Hi Mary,If the door locked after you started the oven! Press Cancel/Off key to start a latch reset, wait 20-30 seconds and open door, or turn the power off at the circuit breaker or fuse box for one minute, then turn the power back on. If the oven has a manual latch handle! Allow the oven to cool, approximately 30-90 minutes, move the latch arm to the left to unlock the door. If the latch arm will not move after cooling to room temperature, or is stuck in between full right and full left positions, schedule service. Is the oven door locked due to power failure during Self-Clean? If the oven door locked due to a power failure during a self cleaning cycle! Select the "Self Clean" option, then select "Cancel". Wait a couple of minutes then try to start the cycle again. If you started the oven clean cycle by mistake! Press Cancel/Off key. The oven will need to cool to approximately 200F(95C) before the oven door will open. Was there an error message! Follow directions in the display, and refer to the Error Code Symptom, or: Reset power to the oven!

• Power the oven down by turning off the circuit breaker(s) or fuse(s) or if you can, unplug the oven for one (1) minute.
• Turn the power back on turning on the circuit breaker(s) or fuse(s) or plugging it back in.
• Monitor the oven for one (1) minute to ensure the error code does not display again.
• Verify the ovens operation.

Kind regards David