Makita Electrical Supplies - Recent Questions, Troubleshooting & Support

$500 to $800 https://www.google.com/search?q=used+Makita+G2800+L+generator ..

it does not have one. copy and paste https://www.manualslib.com/manual/98380/Makita-G2400r.html#manual ..

4KW is marginal for HVAC compressor. Breakers get weak with time. Assuming th gen is running properly and the correct voltage is available. A HVAC unit can take 6 times the start current than it takes to run, so it is possible the inrush is too much

https://www.makita.ca/data/upload/owners_manuals/G2800R.G4100R.G4101R.G6100R.G6101R-USA_owner_English.pdf Contact manufacturer to request a service manual. https://www.makita.ca/data/upload/owners_manuals/G2800R.G4100R.G4101R.G6100R.G6101R-USA_owner_English.pdf

Here is some help information I found. But you should do this stuff at your own risk. https://www.auroragenerators.com/blogs/generators/119728961-fixing-portable-generator-that-have-no-voltage-output If you need further help, I’m available over the phone at https://www.6ya.com/expert/daniel_a4640839dbb7ec58

My guess and the most common complaint on fixya - the gas was left in the engine from the last use and turned to gunk. Drain the old gas. Clean the carb. If it will run for a little after removing the air filter and putting a couple of quick squirts of starter fluid into the carb, it means the carb is gunked up and all the orifices need unstopping.

try checking the oil guage

makita g5501r parts Power Generators Questions & Answers

www.fixya.com > Forum > Tags > makita g5501r parts

Power Generators makita g5501r parts questions and answers. ... I own a makita 6100generator and it is only putting out about 105 volts ac and about 208 volts .

Right above the switch there is a small lever. That's the reverse switch. You can find on page 5 of user manual http://www.makita.ca/data/upload/owners_manuals/FS2200%20-%20EN,FR,SP_owner_English.pdf Regards, Juraj

Owners Manual contain the wiring diagram. Makita Owners Manual

Look on youtube for a video

The float is probably stuck, or there is debris in the needle valve seat. may be time to rebuild the carbureator.

Get the battery tested. The light draws a very small amount of power and will work if the battery is just about dead, but to operate the drill, you need a strong battery.

Try replacing the fuel filter and draing / replacing the fuel with new fuel.

Must be something wrong with the governor or the links near the carb. Check the springs and linkages. These are usually at fault. If thereafter you still don't find something, must be the jets on the carb. One of it maybe a little dirty.

Just noticed your question... If you still need a little help:
1. If the gas is from last year, drain the tank and the carb bowl and replace gas with new. Visually inspect the inside of the tank ..be sure there's no sediment that needs to be cleaned out.
2. remove air cleaner and make sure it's not plugged or dirty
3. plug the spark plug and clean with spray carb cleaner.
4. At end of season, mix some gas stablizer in with the fuel to keep it from going bad while in storage.

Let me know how it goes..
k