Can I watch someone’s internet data from my Linksys app
When you come across a profile that spreads hot news, be wary. Fake profiles have been long used to give an
air of credibility to those who spread fake news on social media.
<a href="http://www.buyinstalike.co.uk"> </a>
<a href="http://www.buyinstalike.co.uk">BUY INSTAGRAM FOLLOWRS UK</a>
7/10/2018 5:50:46 AM •
Linksys...
•
52 views • 0 helpful votes
Setting up a linksys RE6700 that was set up to my old WiFi address to my new WiFi address
The simplest way to reset the range extender is to press and hold the reset button on the side of the unit for 5-10 seconds. The LED will start blinking. The button is recessed and is close to the WPS button. You can use a ballpoint pen or the end of an unfolded paperclip. Now you will have to connect the RE6700 to your router as if it was brand new. See https://www.linksys.com/us/support-article?articleNum=138012 for more information.
I hope this helps.
Cindy Wells
5/5/2018 3:31:27 PM •
Linksys...
•
201 views • 0 helpful votes
I have a linksys cable/dsl
When your 10 computers are connected to the switch, just make sure your ethernet cable is plugged into the ethernet port. The computers should then have a internet connection
3/3/2018 9:42:04 AM •
Linksys...
•
172 views • 0 helpful votes
The Linksys WRT300N router light
You may want to check thr router's settings. There is a web number that you type into your browser that will give you access to the router settings. It is possible that your line connections doesn't have a signal running through it . If you have fios..check your box. If you have cable check your modem
My son gave me an
Reset the router to default....the default username and password is usually on the bottom of the router..then open a web page on your pc and connect the router with a network cable..type 192.168.0.1 or 192.168.1.1
Use the generic name and password to logon....once logged in, configure username and password and wifi...once setup..save and exit..disconnect and connect router to internet modem...log onto pc and look for your wifi neteork name..cheers
1/24/2018 2:24:03 AM •
Linksys...
•
130 views • 0 helpful votes
I can't tune dhcp service
probably not . It is a Wi Fi access point by the sounds of it .
what you need is an additional router between the AP WAP 610N and the modem to provide the DHCP which is a protocol that allows ip addresses to be automatically allocated to computers and devices. So you need a router with a DHCP server built into it. DHCP stands for Dynamic Host Control Protocol.
And the settings for
telnet access, ssh access etc are
protocols and you are most likely thinking of firewall settings which would most likely be in a router.
The firewall can control access to TCP/IP logical port numbers used by the telnet and ssh protocols .
I have a Linksys WRT110.
it means its lost its connection, theres a little reset button near the on off switch normally use a paper clip or safety pin and press for 10 secs and it should start flashing and connect again
Not finding what you are looking for?