I have my wire that
Should have a remote wire off of your radio....
Usually blue in color. Make sure it it says remote. If that don't turn your amp off, try to power antenna wire. One should work
Will my b4 250.0 work
Absolutely. Any car amplifier needs only 12v constant power, Chassis ground, and a switched 12v source to power up. Your switched source is most commonly from the remote turn on lead that comes from your head unit.
I left windows open in
That is a decent amp but I believe the cost is going to be more than the amp is worth at the moment. There are variety of amps in that power range that are inexpensive. I would recommend that you look on either craigslist.org and or ebay. I have picked up several amps from ebay that has cured my needs!
Something to consider: Unless you fried a circuit in the amp, and have seen the smoke or have had that smell of something burning, take the amp out and take a blow dryer to it and let it sit out for couple of nights. Then reconnect it to your system and see what it does. From that point on perhaps you need to decide if buying a different amp is the way to go?
I'm currently driving the two
This is a 2 channel amp. Right and left. It is also only 4 ohm stable. As long as you do not have an ohm load lower then 4 ohms, you can run what you want on it.
However.... If you run 2 more speakers off of this for the front, they would all be on the same rear channel, meaning you will have no fade, and some songs that are designed to have parts of the song louder in the front then the back, will loose some sound.
If you want to run front and rear speakers on an amp in your vehicle, it is best to either have a 4 channel amp,or buy another 2 channel amp. This way you ohm loads will be correct, and your balance and fade will be as well.
Typical setup, 4 channel amp running the front and rear speakers, and a Class D mono block am driving a subwoofer(s) in the trunk area. In place of 1 4 channel amp, you can use two 2 channel amps.
I have only one rca
if you only use the white or the red then you won't have the correct sound so i would say buy a new deck but if you must get a "y" adapter but your bass may not sound right.
What kind of car amp would power these? I had
any amp over 400 watts can power pretty much any sub even one without a sub output just bridge the connection to an amp without sub output. btw a subwoofer does not use as much watts as it says on the sub it usually only take a couple hundred watts to power the sub and make it sound clean
Not finding what you are looking for?