LG Audio Players & Recorders - Page 5 - Recent Questions, Troubleshooting & Support

PCM 2 is basically normal stereo sound. If you want to use Dolby settings it has to be set to bit-stream, or Dolby. However that is in the amp settings. And if it is switching off before you can change it, then it's likely that the protection circuit is sensing an overload caused most likely by either bad speaker wiring, or a bad speaker, or faulty connections. For example two speakers connected to the same channel.

You cannot change the region on the player. If you want to play a region 1 disc, you'll have to use a computer and hook it up to your TV (you can change the region on optical drives a limited amount of times on computers), or acquire a region 1 player. If you're savvy enough, you could rip (using a computer) the disk into a compressed format the LG system can read (MKV, MP4, etc.) and play it off a USB stick.

My Yamaha automatically stops increasing the volume to protect my speakers.

If the TV has an HDMI connection you might not need the optical connection. Plug a good quality HDMI connector into your TV and amp and it should pass the TV sound back to your amp in high quality.

tekan tombol riset yang berada di depan disc anda dan cd pun akan keluar sendirinya

You Need Bluethood

I'm pretty sure your soundbar has more than 1 input. Check your manual. There probably is AUX input on soundbar and that will allow you to connect to TV, assuming that your TV has any audio out. It could be either white and red RCA connectors or headphone jack.

They are wireless bluetooth speakers . You have to sync/pair them to a bluetooth source inorder for them to work. Check the panel and see if there is an input socket or port where you can connect to the source with a cord. However: you will have to supply the cords.